User manual SHARK EP722

[. . . ] OWNER'S MANUAL Model EP722 120V. , 60Hz. , 10. 8 Amps For information or assistance: EURO-PRO Operating LLC 94 Main Mill Street, Door 16 Plattsburgh, NY 12901 www. sharkvac. com IMPORTANT SAFETY INSTRUCTIONS When using your vacuum cleaner, basic safety precautions should always be observed, including the following: 1. Read all instructions before using your canister vacuum. Use the system only for its intended use. To protect against a risk of electric shock, do not immerse any part of the system in water or other liquids. [. . . ] Eastern Standard Time or visit our website: www. sharkvac. com Replacement HEPA filter SKU# XSH722 FOR TECHNICAL SUPPORT for Model EP722 In U. S. : 1 (866) 805-6850 Monday to Friday 8:30 A. M. Eastern Standard Time The HEPA Dust Cup Filter may be washed. We recommend that this be done once a month or when suction appears reduced . To wash your HEPA Dust Cup Filter, hold filter cartridge by frame flange, flange side up and rinse under water. It is important that when you wash the HEPA dust cup filter, you allow it to air dry COMPLETELY before using again. IMPORTANT: Both the Pre-Motor and the Micro Exhaust filters should be replaced every 6 months or sooner if required. All filters should be checked regularly for signs of damage, preferable after each cleaning task. The filters must be replaced immediately if they become damaged. Always disconnect the vacuum from the electrical outlet when checking the filters. Please Note: Important: This vacuum cleaner is equipped with a motor protective thermostat. If for some reason your vacuum overheats, the thermostat will automatically turn the unit off. Should this occur, unplug the vacuum from the wall outlet and turn off the switch. Empty the dust cup, "TapClean" the dust cup filter and check for blockages in hose and suction inlet. Allow the unit to cool for a minimum of 45 minimum prior to restarting the unit. To restart, re-plug the vacuum into the wall socket and turn the switch back on. 1. 8. Hose Cord Rewind Button Power On/off Button Handle Dust Cup Air Intake Duct Air Driven Turbo Brush Dust Cup Handle 9. Telescopic Tube 10. Floor to Carpet Brush 11. Hand Held Air Driven Turbo Brush 12. Upholstery Brush 13. Dusting Brush 14. Crevice Tool 15. Shoulder Strap Technical Specifications Voltage: Power: 120V. , 60Hz. 10. 8 Amps, 1300 Watts 9 2 PRECAUTIONARY MEASURES Important: If the suction opening of the unit, the hose or the chrome telescopic tube are BLOCKED, switch off the vacuum cleaner and remove the blocking substance before you start the unit again. Do not operate the vacuum cleaner too close to heaters or radiators. When pulling out the power plug from the wall outlet, pull the plug not the power cord. OPERATING INSTRUCTIONS Motor Thermostat Important: This vacuum cleaner is equipped with a motor protective thermostat. If for some reason your vacuum overheats, the thermostat will automatically turn the unit off. Should this occur, unplug the vacuum from the wall outlet and turn off the switch. Empty the dust cup, "TapClean" the dust cup filter and check for blockages in hose and suction inlet. [. . . ] Remove the dust cup by lifting the dust cup handle. See illustration below. Dust Cup Handle 4. Take the HEPA dust cup filter out of the dust cup, do not let dust fall out of dust cup. 2. 3. Yellow Red Symbol Symbol Warning: Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding. 5. [. . . ]