User manual SHARK SC505

[. . . ] Proof of purchase date and $ 9. 95 to cover the cost of return shipping and handling must be included. * Non-durable parts including, without limitation, filters, brushes and electrical parts which normally require replacement are specifically excluded from warranty. The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option. This warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes. [. . . ] Eastern Standard Time FOR TECHNICAL SUPPORT for Model SC505 Call: 1-800-798-7398 Monday to Friday 8:30 A. M. Eastern Standard Time or visit our website: www. sharkvac. com Please Note: The HEPA Filter is washable. It should, however, be replaced every six (6) months to ensure peak performance of your vacuum. Both the Pre-Motor and Post Motor Filters are washable. They should however be replaced every three (3) months to ensure peak performance of your vacuum. Make sure that ALL filters have been completely air dried for 24 hours before re-installing back in the vacuum. 8. Important: 9. 14. SAVE THESE INSTRUCTIONS For Household Use Only WARNING: To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. 08/03B 10 OPERATING INSTRUCTIONS cont. Motor Thermostat IMPORTANT: This unit is equipped with a motor protective thermostat. Cleaning & Changing the HEPA Filter (cont. ) PLEASE NOTE: The white pleated filter material in the HEPA Filter will discolor over time -This is NORMAL and will NOT affect the performance of the filter. A "TapCleaned" after each use Wash and suction once a does not return month or when to 100%, then suction we suggest that appears the HEPA filter reduced be "TapCleaned" Warning: Allow 24 vigorously until hours for drying before no more dust replacing in unit. can be removed, then rinsed under the faucet and allowed to dry for 24 hours before refitting into the vacuum. A) This should be done once a month or when suction appears to be reduced . Changing & Cleaning the PreMotor Filter 4. When pulling out the power plug from the wall outlet, pull the plug not the power cord. 2. Before inserting the power plug into the wall outlet, make sure that your hands are dry. 5. Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes. The pre-motor filter is a washable filter but should be replaced every three (3) months. · Remove the dust cup container and the HEPA filter to remove the premotor filter. · Rinse the pre-motor filter in lukewarm water and air dry the filter completely for 24 hours. Do not use a washing machine to rinse the filter. Never operate the vacuum without the pre-motor filter in place. [. . . ] In order to ensure that maximum air suction is maintained, please read the following instructions: 1. Always shake out the HEPA filter and Debris Screen when emptying the dust cup container. Ensure that the rotating brush is kept free of hair and string which may accumulate and decrease brush performance. Keep Air Driven Turbo Brush turbine free of dirt and foreign matter. [. . . ]