User manual SHARP AE-A9NR SUPPLEMENT

[. . . ] • If the remote control does not operate properly after replacing the batteries, press the RESET button using a thin stick. • If you will not be using the unit for a long time, remove the batteries from the remote control. AUXILIARY MODE Use this mode when the remote control is not available. [. . . ] Condensation may form on the louvres. GB- AY-AP9NR_GB. indd 6 11. 9. 30 5:02:55 PM COANDA AIRFLOW In cooling or dry operation, vertical adjustment louver is set obliquely upward to deliver cool air to the ceiling in order to avoid direct airflow. In heating operation, vertical adjustment louver is set downward to deliver the warm air down to the floor. TURBO OPERATION In this operation, the air conditioner fan works at "extra high" speed with a setting temperature of 15°C in COOL and DRY modes and 32°C in HEAT mode to rapidly cool or heat the room. ENGLISH During operation, 1 AIRFLOW button. press the COANDA • The remote control will display “ ”. 1 During operation, press the TURBO button. • The remote control will display “ ”. • The temperature display will go off. • The green TURBO lamp ( ) on the unit will light up. 1 1 TO CANCEL Press the COANDA AIRFLOW button again. TO CANCEL Press the TURBO button again. • The green TURBO lamp ( turn off. ) on the unit will NOTE: If you want the COANDA AIRFLOW setting in the TURBO mode, press the COANDA AIRFLOW button during the TURBO operation. • You can not set the temperature or fan speed during the TURBO operation. • To turn off the TURBO lamp, press the DISPLAY button. • After the unit has run for 30 minutes in TURBO operation, the fan setting will become the "HIGH" speed, and temperature setting will become 18°C in COOL and DRY modes. NOTE: GB- AY-AP9NR_GB. indd 7 11. 9. 30 5:02:56 PM PLASMACLUSTER OPERATION Plasmacluster ions released into the room will reduce some airborne mold. ONE-HOUR OFF TIMER When the ONE-HOUR OFF TIMER is set, the unit will automatically turn off after one hour. 1 During operation, press the PLASMACLUSTER button. • The remote control will display “ ”. • The blue PLASMACLUSTER lamp on the unit will light up. 1 Press the ONE-HOUR OFF TIMER button. • The remote control will displays “ ”. • The orange TIMER lamp ( ) on the unit will light up. • The unit will stop operating after one hour. 1 1 CANCEL TO CANCEL Press the PLASMACLUSTER button again. • The PLASMACLUSTER lamp on the unit will turn off. TO CANCEL Press the CANCEL button. • The orange TIMER lamp ( turn off. ) on the unit will • Use of the PLASMACLUSTER operation will be memorized, and it will be activated the next time you turn on the air conditioner. • To turn off the PLASMACLUSTER lamp, press the DISPLAY button. • To perform Plasmacluster operation in FAN only mode, press the PLASMACLUSTER button when the unit is not operating. [. . . ] (Auto Sleep function) COOL/DRY MODE: • One hour after the time operation begins, the temperature setting rises 1°C higher than the original temperature setting. HEAT MODE: • One hour after the timer operation begins, the temperature setting drops 3°C lower than the original temperature setting. NOTE: • Timer duration can be set from a minimum half an hour to a maximum of 12 hours. [. . . ]