User manual SHARP AE-Z40KR

[. . . ] Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. *) Please contact your local authority for further details. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] Improper cable connection can cause the power supply cord, plug and the electrical outlet to overheat and cause fire. â· If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Use only the manufacturespecified power cord for replacement. 17 NOTE: Actual units might vary slightly from those shown above. Point the remote control towards the receiver window and press the desired button. The unit generates a beep when it receives the signal. â· Make sure nothing, such as curtains, block the signal receiver window. Make sure the (+) and (-) polarities are correctly aligned. The battery life is approximately 1 year in normal use. â· When replacing the batteries, always change both and use the same type. â· If you will not be using the unit for a long time, remove the batteries from the remote control. If you want COANDA AIRFLOW operation in FULL POWER mode, press COANDA AIRFLOW button during FULL POWER operation. Use of the PLASMACLUSTER operation will be memorized, and it will be activated the next time you turn on the unit. â· To perform Plasmacluster operation in FAN only mode, press the PLASMACLUSTER button when the unit is not operating. The mode symbol of the remote control will go off and the fan speed cannot be set to AUTO. SELF CLEAN operation will reduce the growth mold fungus with Plasmacluster ions and dry inside of the unit. When the 1-HOUR OFF TIMER is set, the unit will automatically turn off after 1 hour. The SELF 1 Press the unit isCLEAN button when not operating. The blue PLASMACLUSTER lamp will light up. â· The unit will stop operation after 40 minutes. The blue PLASMACLUSTER lamp will turn off. You cannot set the temperature, fan speed, air flow direction or timer setting during the SELF CLEAN operation. [. . . ] Do not use hot water, thinner, abrasive powders or strong solvents. The filters should be cleaned every two weeks. And turn off the cir3 Clean the filters, then reinstall them. If the filters are dirty, wash them with warm water and a mild detergent. [. . . ]