User manual SHARP AE-A12CR

[. . . ] Please read this manual carefully before operating the product. Do not pull or deform the power supply cord. Pulling and misuse of the power supply cord can result in damage to the unit and cause electrical shock. Be careful not to expose your body directly to the outlet air for a long time. [. . . ] NOTE: Actual units might vary slightly from those shown above. (The heat mode symbol is provided only on models AY-A07CR/AY-A09CR/AY-A12CR) (The heat mode symbol is provided only on models AY-A07CR/AY-A09CR/AYA12CR) Indicates when timer on or timer off is set. At the back of batteries in 2 Insert making surethe compartment, the ± and -- polarities are correctly aligned. ⷠLines will be indicated on the display when batteries are properly installed. The battery life is approximately one year in normal use. ⷠWhen you replace the batteries, always change both batteries, and make sure they are the same type. ⷠIf the remote control does not operate properly after replacing the batteries, take out the batteries and reinstall them again after 30 seconds. ⷠIf you will not be using the unit for a long time, remove the batteries from the remote control. Point the remote control towards the unit's signal receiver window and press the desired button. The unit generates a beep when it receives the signal. ⷠMake sure there is no curtain or other object between the remote control and the unit. ⷠThe remote control can send signals from up to 7 metres away. Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. ⷠUsing a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. AUTO/DRY MODE The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. COOL(HEAT for AY-A07CR/AY-A09CR/AY-A12CR)MODE The temperature can be set within the range of 18 to 32°C. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. To turn off the unit, press the ON/OFF button again. [. . . ] The latest time setting will be memorized and will appear on the remote control display the next time you set the TIMER OFF or TIMER ON. When ONE-HOUR OFF TIMER is set, TIMER OFF and TIMER ON will not be available. ⷠWhen ONE-HOUR OFF TIMER is set during TIMER OFF or TIMER ON duration, the TIMER ON or TIMER OFF will be cancelled. Use this mode when the remote control is not available. [. . . ]