User manual SHARP AF-Q120PX

[. . . ] 5") DRAIN JOINT BOTTOM GASKET WRENCH Q'ty 8 1 1 1 1 The long GOLD SCREW ( ) is used to secure the cabinet to the mounting frame. The short GOLD SCREW( ) is used to secure the front panel to the unit. The DRAIN JOINT ( ) is attached to the outlet on the back of the unit. Cut off the blockage of the drain joint, if outside water drainage is necessary in high humidity district, or if you do not prefer the splashing sound of the non-drain function. [. . . ] 12 E-5 ENGLISH OPERATION INSTRUCTIONS OPERATION INSTRUCTIONS PRECAUTIONS POWER CORD REPLACEMENT WARNING: For replacement, use only the manufacturer specified power cord. replacemant should be conducted by a qualified technician or a serviceman. Consult your dealer for detailed information concerning replacement of the power cord. WAIT FOR 3 MINUTES BEFORE RESTARTING THE COOLING OPERATION Whenever you turn the air conditioner OFF, wait for at least three (3) minutes before restarting the unit. If you restart the air conditioner within three minutes, a protective device in the unit may cause the air conditioner to shut off. This protective device will prevent cooling operation for about 5 minutes. IF A POWER FAILURE OCCURS DURING OPERATION, MAKE SURE TO TURN OFF THE AIR CONDITIONER After resumption of power supply, restart the air conditioner . If the power was off for less than three minutes, make sure to wait for at least three minutes before restarting the unit. If the air conditioner is not turned off during a power failure, the resumption of power supply will cause excessive voltage. The air conditioner will be over-loaded and will not operate for about 5 minutes. tO STOP THE UNIT , TURN THE SELECTOR KNOB TO THE "OFF" POSITION. Experiments may be needed in order to find out the most suitable setting. aUTO SWING SWITCH Use to activate automatic louver movement during LOW COOL , MED COOL and HIGH COOL. Adjust the louvers to change the direction of air flow for uniform and efficient cooling of the room. Set the AUTO SWING switch ON ( ), and the Left/Right air flow adjustment louvers will swing continuously to provide better circulation of cool air. The louvers will be stopped at the position when the switch is turned off. You can also use the switch to adjust the Left/Right air flow adjustment louvers to the desired position. Never attempt to move the Left/Right air flow adjustment louvers manually, or manually force the louver movement to stop during swing operation. The AUTO SWING switch will not activate the louvers when the SELECTOR KNOB is set to FAN. UP/DOWN AIR FLOW ADJUSTMENT Airflow direction can be adjusted by moving the airflow adjustment louvers upward or downward. To avoid condensation on the louvers, please do not adjust these louvers to extremely downward position during LOW COOL, MED COOL and HIGH COOL operation modes for a long time. VENTILATION LEVER If air in your room is stale, set the VENTILATION lever to the RIGHT (OPEN) position. [. . . ] Never use erosive chemicals or abrasive cleaners on any part of the unit. To avoid damaging the unit, do not use hot water of over 50°C when cleaning. oILING OF THE COMPRESSOR AND FAN MOTOR IS UNNECESSARY The compressor is permanently lubricated and is hermetically sealed. The fan motor is lifetime sealed and does not require oiling. [. . . ]