User manual SHARP AL-2021 START GUIDE

[. . . ] The equipment should be installed near an accessible socket outlet for easy disconnection. The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable (moulded) or a rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse to BS1362 marked or and of the same rating as the one removed from the plug must be used. Always refit the fuse cover after replacing the fuse on the moulded plug. [. . . ] A paper form operation manul can be obtained from your authorized SHARP dealder or upon request by contacting SHARP. 78 Please inform the model name, the serial number of the machine and the language needed. Do not forget to add your name and your address. Local voltage ±10% (For this machine's power supply requirement, see the name plate located on the back of the machine. 2 B Sound pressure level LpA (reference) (Bystander positions) Copying mode: 49 dB (A) Standby mode: 19 dB (A) Sound pressure level LpA (reference) (Operator position) Copying mode: 52 dB (A) Standby mode: 19 dB (A) Noise emission measurement in accordance with ISO7779. Copy / printing size Image loss Copy speed * 7 seconds (When user program 24 is set to ON) 0 seconds Variable: 25% to 400% in 1% increments (total 376 steps) Fixed: 50%, 70%, 86%, 100%, 141%, 200% Variable: 50% to 200% in 1% increments (total 151 steps) Fixed: 50%, 70%, 86%, 100%, 141%, 200% Moving optical source, slit exposure (stationary platen) with automatic exposure ­ Heat rollers Magnetic brush development Cold cathode fluorescent lamp 600 x 300 dpi (Auto/Manual mode) 600 x 600 dpi (Photo mode) 600 dpi 600 x 600 dpi 256 levels 2 levels 1 bit or 8 bit/pixel Moving original When standard A4 paper is used under the operating conditions. When making multiple duplex copies, the copy speed will vary based on the environment conditions. Print speed during printing of the second sheet and following sheets when using A4 plain paper in the tray 1 and performing continuous onesided printing of the same page. First copy time may vary depending on the status of the machine. Warm-up time may vary depending on some environments. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. the performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. When ordering supplies, please use the correct part numbers as listed below. Be sure to use only genuine SHARP parts and supplies. Supply TD cartridge Drum cartridge For best copying results, be sure to use only SHARP products. Only genuine SHARP consumables carry the Genuine Supplies label. * Part number AL-214TD AL-100DR Usable life Approx. Based on copying onto letter size paper at 5% toned area (The life of the TD cartridge which has been included in the unit at the factory is approximately 2, 000 sheets. The MSDS (Material Safety Data Sheet) can be viewed at the following URL address: http://www. The label ( , ) in the fusing area of the unit indicates the following: : Caution, risk of danger : Caution, hot surface In some areas, the "POWER" switch positions are marked "I" and " " on the copier instead of "ON" and "OFF". If your copier is so marked, please read "I" for "ON" and " " for "OFF". [. . . ] The products that meet the ENERGY STAR® guidelines carry the logo shown above. The products without the logo may not meet the ENERGY STAR® guidelines. Do not install your unit in areas that are: · Subject to extreme temperature or humidity changes, e. Be sure to allow the required space 20 cm around the unit for servicing and proper ventilation. [. . . ]