User manual SHARP AL-800

[. . . ] To aid in reporting this compact copier in case of loss or theft, please record below the model number and serial number located on the back of the unit. We also suggest you record all the information listed and retain for future reference. For customer assistance, please visit http://www. USER PROGRAMS (power save modes, auto clear time) Setting the power save modes and auto clear time Original table and original cover Cleaning the drum cartridge When copier is not in use This chapter provides basic information for using the copier. [. . . ] If some parts of the images are missing from the printed page, you may need to clean the surface of the drum in the drum cartridge. Because the drum surface is very sensitive, you must take extreme care when cleaning it, otherwise it may become damaged, and any damage to this component will have a serious effect on the print quality. Follow the procedure below to clean the drum surface. Put the drum cartridge down on a clean, uncluttered and level surface. The drum can easily become damaged if it is not handled with care. Take a sheet of clean paper and roll it into a tube. Roll it tightly so that the diameter of the hole at each end is less than the thickness of your little finger. Gently rub the surface of the drum (green portion) with the rolled-up paper to remove any particles of toner caking on the drum. Do not touch the drum surface with the edges of rolled-up paper. Do not let the drum surface come into contact with anything other than the rolled-up paper. Close the front cover and turn on the copier power. When copier is not in use Remove the power cord and the interface cable (AL-840 only) and secure the copier using tape (two locations). If this copier is not in use for a long time, remove the copy paper from the paper tray and store it in a location that is not humid. If the copy paper is left in the paper tray for a long time, it will absorb moisture, resulting in paper misfeeds. When the misfeed ( ) indicator blinks or blinks in the display, the copier will stop because of a misfeed. Remove the misfed paper following the instructions for each location shown in the illustration below. If the paper is misfed here, proceed to "A. If the misfed paper is seen from this side, proceed to "C. 36) If paper is misfed here, proceed to "B. Pull the paper release lever at the right of the paper tray toward you. Remove all the paper, including the jammed paper, from the paper tray. If the misfed paper will not come out easily, do not pull it hard, as you may tear it or damage the printing mechanism. [. . . ] However, you are responsible for the required user maintenance described in the Operation Manual. This requires user maintenance including replacement of the TD cartridge and drum cartridge, cleaning of the unit and transfer charger, removal of dust and foreign matter, clearing of paper misfeeds, and proper routine and preventive maintenance. Service After Expiration of Warranty Coverage Should you require service repair after warranty coverage has expired, contact Sharp at 1-630-378-3590 for information. SHARP ELECTRONICS CORPORATION warrants to the first end-user purchaser that this Sharp brand product (the "Product"), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. [. . . ]