User manual SHARP AL-840

[. . . ] This equipment complies with the requiremenlS ofDirectives 891336IEEC and 73123IEEC asamended by 93/681EEC. WARNING: FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed 10 provide reasonable protection against harmful Interference in a residential Jnstauatlon. [. . . ] Then ensure that Yes is checkedto use this printer as the default printer. When the installation is complete, click the Yes button. Read the description with the operation manual for the application to be used. â· Before you can use your printer, you must install the printer driver which has been supplied with the printer. Once this software has been installed, you I. Can control the printing of your documents from the printer driver which When using multiple pnntars, you must change the printer setting from the control panel to change the printer to be used. This printer cannot be used with other GOl printers and printers that use the Windows Printing System. Ensure that paper of the desired size is loaded in the paper tray. (See the section on LOADING COpy PAPER in the copier operation manuai. ) To print onto special paper, feed it one sheet at a time. Select the settings for printing such as the number of sets and paper type from the application. If copying is being performed when printing is initiated, copying will continue. After copying is complete, printing will be executed when the clear (@) key is pressed twice or approximately 60 seconds (auto clear time)* elapse. __ * The auto clear time varies with a user program setting. Preheat mode and auto power shut-off mode will be canceled when printing is started. If the paper size specified from the sonware application is larger than l, be paper size in the printer, the image may be printed onto two sheetsof paper. Elf the paper size specified from the software application is larger than, the Paper size in the printer, part of the image that is not transferred to the paper may remain on the surface of the drum. In, this case, the other side of the paper may becomedirty. ~ print two or three pages to clean the image. , j'; Blinking: Indicates copier setting is be, ing perforrTled during printing or data:is, being:re~e'ived from a computer. Power save indicator On: lndlcates the printer is in a power save mode. Use Windows 95/Windows 98, click the Driver Setup tab to display the following screen. [. . . ] Check the cable with a computer and printer which you know work. if printing is stili not possible , the interiace cable is defective. Check the printer settings in the Windows Control panel to make sure that the print job is being sent to the correct port (for example, LPT1). The printer maybe con figured incorrectly. [. . . ]