User manual SHARP AR-120E/150E

[. . . ] In some areas, the "POWER" switch positions are marked "I" and "0" on the copier instead of "ON" and "OFF". CAUTION: For a complete electrical disconnection, pull out the main plug. The socket-outlet shall be installed near the equipment and shall be easily accessible. 1 2 3 4 5 6 7 8 Original cover Side cover Manual bypass Paper guides Side cover open button Front cover Papier tray Operation panel 9 Original table 10 Cover for optional printer interface 11 Paper output tray 12 Paper output tray extension 13 Handle 14 Power switch 15 Power cord socket 16 TD cartridge lock release button 17 TD cartridge 18 Drum cartridge 19 Drum cartridge handle 20 Transfer charger 21 Charger cleaner 22 Fusing unit release tab 23 Paper feed roller 3-8) 2 Light ({) and dark (}) keys and exposure indicators Use to adjust the MANUAL (=) or PHOTO ( ) exposure level. [. . . ] To further reduce or raise the zoom ratio, firstly release the key and then press and hold down. Set the number of copies using the copy quantity (<, <) keys and press the print ( ) key. The single-sheet manual bypass can be used to feed standard paper, transparency film, labels and other special purpose papers measuring from A6 to A4 and in the weight range of 52 to 130 g/m². (For paper weighing from 104 to 130 g/m², A4 is the maximum size. Align it with the original scale and close the original cover. The original image must be smaller than the paper or media for copying. If the original image is bigger than the paper or media, this may cause smudging on the edges of the copies. Set the paper guides to the copy paper width. Insert a single sheet of copy paper (print face down) into the feed slot of the manual bypass. Paper must be fed narrow side into the feed slot. ⷠWhen copying onto transparency film, remove each copy promptly. Two-sided copying can be made on this copier using the manual bypass. Example: The following two originals will be copied onto two sides of copy paper. Place the first original on the original table and make a copy. The user programs allow the parameters of certain functions to be set, changed, or cancelled as desired. Setting the power save modes and auto clear time. Press and hold down the light ({) and dark (}) keys simultaneously for more than 5 seconds until all the alarm indicators (w, t, s, p ) blink and "­ ­" appears in the display. Use the left copy quantity (<) key to select a user program number. The selected number will blink in the left side of the display. The entered program number will be steadily lit and the currently selected parameter number for the program will blink on the right side of the display. Factory default settings are indicated with an asterisk (*). Select the desired parameter using the right copy quantity (<) key. [. . . ] If any problem occurs, check the list below before contacting the Sharp Service Center. In the cases described below, the copier does not malfunction. Is original image too dark or too light?Gently close the front cover and then close the side cover. [. . . ]