User manual SHARP AR-5015

[. . . ] MODEL AR-5015 DIGITAL LASER COPIER OPERATION MANUAL Page · GETTING STARTED 2 · MAKING COPIES 13 · STATUS INDICATORS 28 · GENERAL INFORMATION 35 CAUTIONS Follow the cautions below when using this copier. q q The fusing area is hot. Exercise care in this area when removing misfed paper. Do not look directly at the light source. Doing so may damage your eyes. q q q Place the copier on a firm, level surface. [. . . ] Doing so may cause toner to leak from the cartridge. Put the old cartridge immediately in the bag contained in the box of the new cartridge. Grip 4 or 5 times 4 Tape Remove the new toner cartridge from the bag. Grasp the cartridge on both sides and shake it horizontally four or five times. After shaking the cartridge, remove the tape. Grasp the grip when holding the cartridge. Do not hold the cartridge by the shutter. Be sure to only shake the cartridge before the tape is removed. Shutter 28 TONER CARTRIDGE REPLACEMENT 5 Gently insert the toner cartridge along the guides until it locks in place while pushing the lock release lever. If dirt or dust is adhered to the toner cartridge, remove it before installing the cartridge. 6 7 Remove the tape from the shutter. Pull the shutter out of the toner cartridge as shown in the illustration. Close the front cover by pushing both sides with your hands and then close the side cover by pressing the indicator will go out. The When closing the covers, be sure to close the front cover securely and then close the side cover. If the covers are closed in the wrong order, the covers may be damaged. Even after a new toner cartridge is installed, the START key ( ) indicator may not light up, indicating copying cannot be restarted (toner is not sufficiently fed). In this case, open and close the side cover. The copier will feed toner again approximately 2 minutes and then copying can be restarted. STATUS INDICATORS Toner cartridge replacement Toner cartridge life To find out the approximate quantity of toner remaining, follow the procedure below. 1 2 3 Press and hold the light ( ) key for more than 5 , , , seconds until all the alarm indicators ( , ) blink and "­­" appears in the copy quantity and display. Press and hold the copy ratio display ( than 5 seconds. q ) key for more The approximate quantity of toner remaining will be indicated in the copy quantity display as a percentage. ( "100", "75", "50", "25", or "10" is displayed. ) When the percentage is less than 10%, "LO" will be displayed. Press the light ( q ) key. All the alarm indicators will go out. 29 MISFEED REMOVAL The copier will stop when a misfeed occurs. The misfeed ( ) indicator and the misfeed location ( ) indicator will blink. If paper is accidentally torn during removal, be sure to remove all pieces. Be careful not to damage the photoconductive drum. STATUS INDICATORS Misfeed in the bypass tray 1 2 Gently pull the misfed paper out. Misfeed removal Lift slightly on the side cover and slide the cover out until it stops. Close the side cover by pressing the handle on the cover. q The misfeed ( ) indicator will go out. Misfeed in the copier 1 30 Open the bypass tray. Lift slightly on the side cover and slide the cover out until it stops. MISFEED REMOVAL 2 If the misfed paper is seen from this side, proceed to C. Misfeed in the transport area . Check the misfeed location. Remove the misfed paper following the instructions for each location in the illustration below. If paper is misfed here, proceed to B. [. . . ] A6 (5-1/2" x 8-1/2") Image loss: Max. 4 mm (5/32") (leading and trailing edges) Max. 4 mm (5/32") (along other edges in total) 15 copies/min. (A4 (8-1/2" x 11")) 12 copies/min. [. . . ]