User manual SHARP AR-5618N/5620N/5623N SPLCPRINTER/TWAIN DRIVERWIN32

[. . . ] â· Do not look directly at the light source. â· Do not switch the unit rapidly on and off. After turning the unit off, wait 10 to 15 seconds before turning it back on. â· Unit power must be turned off before installing any supplies. [. . . ] When the unit power is on, the operation panel will revert to the initial settings when the time set with the "Auto clear time" setting (p. 18) elapses after a copy is finished, or when the clear ( ) key is pressed twice. When copying is begun in this state, the settings in the following table are used. Copy quantity Exposure adjustment Zoom Tray 1 copy AUTO 100% Paper tray 1 If not used for a certain period of time, the unit will automatically enter auto power shut-off mode (p. 19) in order to minimise power consumption. In cases where the machine will not be used for a long time, turn off the power switch and remove the power cord from the outlet. 5mm in total can occur along the other edges of the copies. â· When copying a book or an original which has been folded or a crumpled original, press down the original cover lightly. If the original cover is not securely closed, the copies may be striped or blurred. The original cover can be removed to allow copying of bulky objects. Simply lift the original cover straight up. Three preset reduction ratios and two enlargement ratios can be selected. The zoom function enables copy ratio selection from 25% to 400% in 1% increments. Use the copy ratio selector key and/or ZOOM ( select the desired copy ratio. To verify a zoom setting without changing the zoom ratio, press and hold down the copy ratio display (%) key. When the key is released, the display will return to the copy quantity display. â· To reset the ratio to 100%, press the copy ratio selector key repeatedly until the 100% indicator lights up. To move beyond these ratios, release the key and then press and hold it down again. To select a zoom ratio: When a ZOOM ( or ) key is pressed, the ZOOM indicator will light up and the zoom ratio will be displayed in the display. This chapter describes the special functions of this unit. Use the left copy quantity ( ) key to select a user program number (1: auto clear time, 2: preheat mode, 3: auto power shut-off timer, 5: auto power shut-off mode 6: resolution of AUTO & MANUAL mode). The selected number will blink in the left side of the display. [. . . ] Raise the fusing unit release lever and then close the side cover by pressing the round projections near the side cover open button. The misfeed ( ) indicator will go out and the start ( ) indicator will light up. Raise the fusing unit release lever, close the front cover and then close the side cover by pressing the round projections near the side cover open button. The misfeed ( ) indicator will go out and the start ( ) indicator will light up. [. . . ]