User manual SHARP AR-C200P

[. . . ] Digital full colour Printer Network Interface Guide Model AR-C200P PREFACE Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. The manufacturer assumes no responsibility for the results of errors beyond its control. The manufacturer also cannot guarantee that changes in software and equipment made by other manufacturers and referred to in this guide will not affect the applicability of the information in it. Mention of software products manufactured by other companies does not necessarily constitute endorsement by the manufacturer. [. . . ] By selecting the button, the following dialogue box is displayed: In the dialogue box, the following items can be configured: Trap Enable Set sending a Trap packet, enabled or disabled, for each destination. Set sending a Trap packet, enabled or disabled, when the printer is rebooted. Set sending a Trap packet, enabled or disabled, when the printer receives an illegal Trap packet. Printer Reboot Receive Illegal Network Configuration 41 Location Printer Trap Setup . On-line Set sending a Trap, enabled or disabled, when the printer turns to ON-LINE. Set sending a Trap, enabled or disabled, when the printer turns to OFF-LINE. Set sending a Trap, enabled or disabled, when paper is out. Set sending a Trap, enabled or disabled, when a paper jam occurs. Set sending a Trap, enabled or disabled, when the printer cover opens. Set sending a Trap, enabled or disabled, when any errors occur. Off-line Paper Out Paper Jam Cover Open Printer Error Network Configuration 42 POP Tab This allows you to configure POP related items. Location Use POP3 Protocol Comments Set retrieving E-Mail via POP3, enabled or disabled. POP3 Server Address/ Set IP address or host name of POP3 server. Name POP3 Port Number POP3 Server UserID POP3 Server Password Use APOP POP3 Interval Set port number of POP3. Set interval to retrieve E-Mail(s) from POP3 server. Set to OFF if you do not want to use POP3 function. Some printers support an email reception function (SMTP/POP3) allowing the printer to print PDF and text files attached to emails. If the POP tab is not displayed, your printer does not support this function. Network Configuration 43 SMTP Tab In SMTP Tab, you can configure SMTP related items. Location Use SMTP Transmit Protocol Use SMTP Receive Protocol SMTP Server Address/Name Reply-To Address E-Mail Address Comments Set sending E-Mail via SMTP, enabled or disabled. Set receiving E-Mail via SMTP, enabled or disabled. Set IP address or host name of SMTP server. Set the E-Mail address that is used in the [Reply-To] field in the mail header. Set the E-Mail address that is used in the [From] field in the mail header. Network Configuration 44 Location 1--5 Comments By selecting each button, the following dialogue box is displayed: In the dialogue box, the following items can be configured: Available condition and Selected condition Select each E-Mail alert condition. Select a condition from Available Condition list and click >> button. The selected condition is copied to Selected condition list. Available conditions are: Off line, Consumable Message, Toner Low/ Out, Paper Low/Out, Paper Jam, Cover Open, Stacker Error, Mass Storage Error, Recoverable Error, Service Call Request and Finisher Error. 1-5 To Address 1--5 Set E-Mail addresses to that E-Mail should be send. Set interval that the printer checks specified event(s). [. . . ] Turn the banner output Off in the client's printer settings. EtherTalk Not identified by the Chooser and the Setup Utility. Troubleshooting 88 Turn the printer off and on again. Check the network cable is correctly connected. If the network resides in a Zone, check the correct Zone name is selected in the Chooser. Check the Zone name in the utility related to the NIC is the same as the Zone name set in NIC. [. . . ]