User manual SHARP AR-FX3

[. . . ] AR-150 SERIES FACSIMILE OPERATION MANUAL c INSTALLATION c INITIAL SETTINGS c CHOOSING SUITABLE MEDIA c HOW TO USE THE FAX FUNCTION c TROUBLESHOOTING c SPECIFICATIONS c GLOSSARY c QUICK REFERENCE c INDEX Cover page(SUK). p65 1 21/09/99, 16:16 This product contains a lithium-ion battery, and must be disposed of properly. Contact your local environmental officials for disposal instructions. Important safety information · If any of your telephone equipment is not operating properly, you should immediately remove it from your telephone line, as it may cause harm to the telephone network. · The AC power outlet shall be installed near the equipment and shall be easily accessible. · Never install telephone wiring during a lightning storm. [. . . ] The area of a document that is scanned by the unit while faxing is slightly smaller than the actual document (original) size. Any text or graphics outside this area will not be scanned. Scanning length: The length of the sheet minus 4mm from both the top and bottom edges. CHOOSING SUITABLE MEDIA 3-1 21/09/99, 09:50 03_CHOOSING(SUK) A5. p65 1 Originals Suitable for Faxing Unsuitable Originals General guidelines: · All clips, staples, and pins should be removed from originals before they are used. If these are not removed, they may damage the unit. · Ink, glue, and correction fluid on originals must be completely dry before using the documents with the unit. · Originals that are in some way dangerous to the internal mechanisms of the unit should not be used. · When faxing, any writing on the originals that is yellow, yellowish-green, or light blue cannot be transmitted. The following kinds of originals should not be used: · Originals with a glossy coating · Originals with static electricity · Originals with tears, folds, or curls · Originals that have become stuck together and cannot be easily separated · Originals with holes, windows, or perforations · Transparency films, tracing paper, or other transparencies · Originals with plastic or metallic coatings Notes: · Sharp does not accept any responsibility for the loss or damage of originals. · It is a good idea to copy valuable originals on a flat-bed copier before using them with the unit. 3-2 03_CHOOSING(SUK) A5. p65 2 CHOOSING SUITABLE MEDIA 21/09/99, 09:50 4. HOW TO USE THE FAX FUNCTION The standalone fax component of your unit offers a range of sophisticated features that allow you to control image quality, reception mode, broadcasting, polling, and transmission priorities. Functions such as sending documents from memory and substituting reception into memory are greatly enhanced by the large memory capacity. Sending Documents Setting the Document This section describes setting documents in the SPF (Single Pass Feeder) or on the original table. When Using the SPF: 1 Confirm that there are no documents on the original table, and that copying is not in progress, then gently close the original cover. Adjust the document guides to the width of your document. 2 3 Place the document face up and push it gently into the document tray. The top edge of the document should enter the fax first. Original face up 4 · There are two ways to send the fax: · To scan the document into memory, then dial and transmit, continue with the "Dialing and Transmitting" section. To dial and transmit the document directly without first scanning it into memory, press the DOCUMENT key. "DIRECT SEND" will appear in the display. Continue with the "Dialing and Transmitting" section. HOW TO USE THE FAX FUNCTION 4-1 04 USING FAX b(SUK) A5. p65 1 11/10/99, 17:28 Sending Documents When placing the Original on the Table: 1 2 Confirm that there are no documents in the SPF, and open the original cover. Place the document face down on the original table. Align the document according to the original scale in the illustration below. (Line up the center of the edge of the document with the ( ) mark. ) Original scale mark 3 4 5 Gently close the original cover. Note: When using the original table, do not set documents in the SPF. Press the BOOK SEND key to scan the page into memory. Select the document size from those displayed. You can now make resolution or contrast settings as described in the next section and dial and transmit the fax. (See "Dialing and Transmitting" in this chapter) 6 Press the BOOK SEND key. If you have more than one document to read into memory, place the next page, and press the BOOK SEND key to read each page. 4-2 04 USING FAX b(SUK) A5. p65 HOW TO USE THE FAX FUNCTION 2 11/10/99, 17:28 Sending Documents Optional Transmission Settings There are several transmission settings that you can make before dialing and transmitting a document. Resolution Your fax has four resolution settings: · HALF TONE Use HALF TONE for photographs and illustrations. [. . . ] Mermelstein (1991) Pulmonary Response to Toner upon Chronic Inhalation Exposure in Rats. Fundamental and Applied Toxicology 17, pp. 280-299 License 0(SUK) A5. P65 3 22/09/99, 16:45 PUMA_1530_Front1. p65 20 08/04/99, 14:47 PUMA_1530_Front1. p65 20 08/04/99, 14:47 PUMA_1530_Front1. p65 20 08/04/99, 14:47 License Agreements This equipment complies with the requirements of Directives 98/13/EC, 89/336/EEC and 73/23/ EEC as amended by 93/68/EEC. Dieses Gerät entspricht den Anforderungen der EG-Richtlinien 98/13/EWG, 89/336/EWG und 73/23/EWG mit Änderung 93/68/EWG. [. . . ]