User manual SHARP AR-M280

[. . . ] LASER PRINTER (Multi-function printer) Operation Manual for printer operation and general information on multi functions INSTALLATION REQUIREMENTS Improper installation may damage this product. Please note the following during initial installation and whenever the machine is moved. 1. The machine should be installed near an accessible power outlet for easy connection. 2. Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements. [. . . ] G Total count . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The number of printed pages and the like are displayed. (See page xxxx. ) G Display contrast*1 . . . . . . . . . . . . . . . . . . . . . . . . . . . The display contrast of the operation panel is adjusted. (See page xxxx. ) G List print . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Used to print a list of settings that have been made or a font list. (See page xxxx. ) G Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The date and time of the built-in clock of the printer are set. G Tray settings*4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The paper type and paper size for each tray are set. G Auto tray switching . . . . . . . . . . . . . . . . . . . . . . . . . . Used to switch automatically the paper tray of the same paper size when paper runs out in continuous printing. For the items below, detailed setting procedure is described on the respective pages of the functions. G Address control*3 . . . . . . . . . . . . . . . . . . . . . . . Used to register destination E-mail addresses, fax numbers, and Internet fax addresses. Also group entry, memory box entry, custom index entry, and scanner sender entry can be set. G Receive mode*2 . . . . . . . . . . . . . . . . . . . . . . . . . The fax receive mode (automatic or manual) is set. G Fax data forward*2 . . . . . . . . . . . . . . . . . . . . . . Received fax data in memory can be forwarded to another destination. G Key operator programs . . . . . . . . . . . . . . . . . . . . RSetting programs are provided for key operators (administrators of this machine). [. . . ] The program will be effective at this time. *1 Store current configuration Use this program to store the current settings of the configuration settings (page xx) and the system settings (default settings/interface settings) of the key operator programs (pages xx to xx) in the printer's nonvolatile memory. To recall the stored settings, use the program "Restore configuration" below. *1 Restore configuration Use this program to recall the configuration settings that have been stored in the printer's nonvolatile memory using the program "Store current configuration" above. NOTE If this program is executed when the setting of "Enable TCP/IP", "Enable NetWare", "Enable EtherTalk" or "Enable NetBEUI" has been changed, exit the key operator program, turn off the main switch, and then turn on the main switch again after a while. The program will be effective at this time. 6-14 CHAPTER 7 APPENDIX This chapter describes detailed information of this product such as specifications. Page PRINTER SPECIFICATIONS . LIST OF COMBINATION OF PERIPHERAL UNITS . [. . . ]