User manual SHARP AR-150DC

[. . . ] In some areas, the "POWER" switch positions are marked "I" and "0" on the copier instead of "ON" and "OFF". CAUTION: For a complete electrical disconnection, pull out the main plug. The socket-outlet shall be installed near the equipment and shall be easily accessible. This equipment compiles with the requirements of Directives 98/13/EEC and 89/336/EEC, 73/23/EEC both amended by 93/68/EEC. [. . . ] 5 Auto power 0¶OFF shut-off mode * 1¶ON Factory default settings are indicated with an asterisk (*). (1) For other countries, except Great Britain, the value is *0¶30 sec. Select the desired parameter using the right copy quantity (<) key. To change the setting or to set another mode, press the clear (>) key. Press the light ({) or dark (}) key to return to the normal copy mode. Be sure to use only genuine SHARP parts and supplies. The TD cartridge replacement required (s) indicator will light up when toner is needed. If copying is continued while the indicator is lit, copies will gradually become lighter until the copier stops and the indicator begins blinking. Replace the old TD cartridge by following the procedure given below. After the copier stops, it may be possible to make a few more copies by taking the TD cartridge out of the copier, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the TD cartridge. During a long copy run of a dark original, the ready ( ) indicator may blink, the s indicator light up, and the copier stop, even though toner is left. The copier automatically replenish the toner level for up to 2 minutes and then the ready ( ) indicator will light up. Ensure that the bypass tray is open and then open the side cover while pressing the side cover open button. Then, push gently on both sides of the front cover to open the cover. Gently pull the TD cartridge out whilst pressing the lock release button. Dispose of the old TD cartridge in accordance with local regulations. Hold the cartridge on both sides and shake it horizontally four or five times. Hold the tab of the protective cover and pull the tab towards you to remove the cover. Close the front cover and then the side cover by pressing the round projections near the side cover open button. The s indicator will go out and the ready ( ) indicator will light up. When closing the covers, be sure to close the front cover securely and then close the side cover. [. . . ] Moreover, a two-year cancer bioassay using a typical toner preparation containing carbon black demonstrated no association between toner exposure and tumor development in rats. Chronic Effect : In a study in rats of chronic inhalation exposure to a typical toner, a mild to moderate degree of lung fibrosis was observed in 92% of the rats in the high concentration (16mg/m3) exposure group, and a minimal to mild degree of fibrosis was noted in 22% of the animals in the middle (4mg/m 3) exposure group, but no pulmonary change was reported in the lowest (1mg/m3) exposure group, the most relevant level to potential human exposures. Signs and Symptoms of Exposure : Minimal irritation to respiratory tract may occur as with exposure to any non-toxic dust. Health Hazard Data (Continued) Emergency and First Aid Procedures : Inhalation ; Remove to fresh air. [. . . ]