User manual SHARP AR-C260P

[. . . ] MODEL AR-C260P DIGITAL FULL COLOUR PRINTER OPERATION MANUAL (for printer) Page · BASIC PRINTING PROCEDURES · SETTING THE PRINTER DRIVER PROPERTIES · WEB PAGES IN THE PRINTER · TROUBLESHOOTING 1-1 2-1 3-1 4-1 Be sure to become thoroughly familiar with this manual to gain the maximum benefit from the product. Before installing this product, be sure to read the installation requirements and cautions sections of the "Operation manual (for general information)". Be sure to keep all operation manuals handy for reference including this manual, the "Operation manual (for general information)" and operation manuals for any optional equipment which has been installed. The CE mark logo label is affixed on an equipment in case that the directives described in the above sentence are applicable to the product. (This sentence is not applicable in any country where the above directives are not required. ) Warranty While every effort has been made to make this document as accurate and helpful as possible, SHARP Corporation makes no warranty of any kind with regard to its content. [. . . ] Default setting: Username unknown [Job Name] Use this setting to select the default "Job Name" that appears in the machine's operation panel. If "Always Use This ID" is selected, the name entered here will appear in the machine's operation panel. If "Always Use This ID" is not selected, the job name set in the application will be automatically used. Default setting: Jobname unknown [Always Use This ID] This allows you to select whether to automatically obtain the "User Name" and "Job Name" displayed in the machine's operation panel, or whether to use the names entered in this dialog box. The Windows login name will be automatically used for the "User Name", and the job name set in the application will be automatically used for the "Job Name". The names entered in this dialog box will appear in the machine's operation panel. Default setting: Not selected 2-7 SELECTING PRINTING FUNCTIONS Paper settings The following screen appears when the Paper tab is selected. The settings and buttons in this screen are explained below. Paper Size Select the size of paper to be printed on. Click one of the paper sizes that appear in the list. Default setting: A4 [Custom] A custom paper size can also be set. Click this button to set the custom paper size (only one custom paper size can be set). When printing with a custom paper size, the paper must be loaded horizontally. Correct Wrong [Fit To Page] When this checkbox is selected, the print image corresponding to the paper size selected in [Paper Size] is automatically reduced or enlarged to fit the paper selected in [Fit To Paper Size]. Default setting: Not selected Image Orientation Set the orientation of the document. Default setting: Portrait [Rotate 180 degrees] Rotate the image 180° before printing. This function rotates the image to enable correct printing on envelopes and other paper with flaps. Default setting: Not selected Horizontal loading Vertical loading Fit To Paper Size This field is used for the Fit to Page function. This function automatically enlarges or reduces the printed image to match the paper being used. Enlargement or reduction takes place with the image centred on the page. To use this function, select the "Fit to Page" checkbox and then select the size of paper to be used. NOTE Printing normally takes place using the paper size set in the application, regardless of the paper size selected in the printer driver. When the paper size is not specified in the application, the paper size setting in the printer driver is used. 2-8 SELECTING PRINTING FUNCTIONS Paper settings (continued) Paper Selection Select the paper tray and paper type in this field. [. . . ] badly curled, Message to add staples displayed? Cannot be punched. *2 The punch positions are correct*2 Message to check the punch waste box Dispose of punch scraps. Operation Manual (for general information). ) hole The punch function is not set to the correct Check the allowed hole punch positions. (page 2-5) not punch positions. *2:When a Punch module is installed. 4-4 TROUBLESHOOTING Checking the IP address There are three ways to check the IP address: 1. Using "PRINT LIST" in "CUSTOM SETTINGS" in the operation panel Select NIC PAGE to print a list of the machine settings. [. . . ]