User manual SHARP AY-A12GR

[. . . ] *) Please contact your local authority for further details. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. During de-icing, the inside and outside fans stop operating. ⷠAfter de-icing is completed, the unit automatically resumes operation in the HEAT mode. The unit employs a heat pump that draws heat from the outside air and releases it into the room. The outside air temperature therefore greatly affects the heating efficiency. ⷠIf the heating efficiency is reduced due to low outside temperatures, use an additional heater. ⷠIt takes time to warm up and heat the entire room because of the forced air circulation system. Below are some simple ways to save energy when you use your air conditioner. Setting the thermostat 1°C higher than the desired temperature in the COOL mode and 2°C lower in the HEAT mode will save approximately 10 percent in power consumption. ⷠSetting the temperature lower than necessary during cooling operation will result in increased power consumption. Blocking direct sunlight during cooling operation will reduce power consumption. The temperature can be set within the range of 18 to 32°C. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature when the unit is turned on. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. To turn off the unit, press the ON/ OFF button again. ⷠThe red OPERATION lamp ( unit will turn off. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. The adjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for adjustment. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. Do not adjust the horizontal adjustment louvre to the extreme left or right in the COOL mode with the fan speed set to "SOFT( )" for an extended period of time. The unit will turn off automatically according to your setting. [. . . ] ⷠIf you wish to operate the unit for another hour before the ONE-HOUR OFF TIMER is activated, press the ONE-HOUR OFF TIMER button again during operation. The Plasmacluster ion generator inside the air conditioner will release positive and negative Plasmacluster ions into the room. Approximately the same numbers of positive and negative ions released into the air will reduce some airborne mold. The blue PLASMACLUSTER lamp on the unit will light up. [. . . ]