User manual SHARP AY-A249E-T

[. . . ] Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. *) Please contact your local authority for further details. Attention: Your product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] 11 This appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. CAUTIONS FOR LOCATION / INSTALLATION Make sure to connect the air conditioner to power supply of the rated voltage and frequency. Use of a power supply with improper voltage and frequency can result in equipment damage and possible fire. Do not install the unit in a place where inflammable gas may leak. Install the unit in a place with minimal dust, fumes and moisture in the air. Arrange the drain hose to ensure smooth drainage. Insufficient drainage may cause wetting of the room, furniture etc. Make sure a leak breaker or a circuit breaker is installed, depending on the installation location, to avoid electrical shock. E-2 ADDITIONAL NOTES ON OPERATION OPERATING TEMPERATURE RANGE INDOOR TEMP. upper limit COOLING lower limit HEATING D. B. The built-in protective device may prevent the unit from operating when used out of this range. Condensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 percent. 20C D. B. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. Using a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. The unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. Do not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. E-7 ENGLISH BASIC OPERATION 1 Press the MODE button to select the operation mode. AUTO HEAT COOL DRY 2 2 5 3 1 4 Press the ON/OFF button to start operation. The red OPERATION lamp ( unit will light. Approximately the same numbers of positive and negative ions released into the air will reduce some airborne mold. 1 During operation, press the PLASMACLUSTER button. The remote control will display " ". The blue PLASMACLUSTER lamp on the unit will light up. TO CANCEL 1 Press the PLASMACLUSTER button again. The PLASMACLUSTER lamp on the unit will turn off. NOTES: Use of the PLASMACLUSTER operation will be memorized, and it will be activated the next time you turn on the air conditioner. To turn off the PLASMACLUSTER lamp, press the DISPLAY button. When the PLASMACLUSTER button is pressed while the unit is not operating, the PLASMACLUSTER operation will be performed without accompanying air conditioning mode (eg, HEATING or COOLING). The mode symbol of the remote control will go off and the fan speed can not be set AUTO. E-10 TURBO OPERATION In this operation, the air conditioner fan works at "extra high" speed with a setting temperature of 15C in COOL and DRY modes and 32C in HEAT mode to rapidly cool or heat the room. 1 Press the TURBO button during operation. The remote control will display " ". The green TURBO lamp ( ) on the unit will light up. TO CANCEL Press the TURBO button again. TURBO operation will also be cancelled when the operation mode is changed, or when the unit is turned off. [. . . ] The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode. The fan speed and temperature setting are set to AUTO. (AY-AP7FHR/AY-AP9FHR) TO TURN OFF Press the AUX. ) on the unit will The red OPERATION lamp ( turn off. (AY-AP12FHR) NOTE: If the AUX. button is pressed during normal operation, the unit will turn off. E-14 MAINTENANCE Be sure to disconnect the power cord from the wall outlet or turn off the circuit breaker before performing any maintenance. CLEANING THE FILTERS The air filters should be cleaned every two weeks. 1 TURN OFF THE UNIT 2 REMOVE THE FILTERS 1 2 3 1 Lift the open panel. [. . . ]