User manual SHARP AY-A9GR

[. . . ] *) Please contact your local authority for further details. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] If the timers were set before a power failure, they will need to be re-set after power recovery. In the HEAT operation, the indoor fan may not start for two to five minutes after the unit is turned on to prevent cold air from blowing out of the unit. When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. During de-icing, the inside and outside fans stop operating. ⷠAfter de-icing is completed, the unit automatically resumes operation in the HEAT mode. The unit employs a heat pump that draws heat from the outside air and releases it into the room. The outside air temperature therefore greatly affects the heating efficiency. ⷠIf the heating efficiency is reduced due to low outside temperatures, use an additional heater. ⷠIt takes time to warm up and heat the entire room because of the forced air circulation system. Below are some simple ways to save energy when you use your air conditioner. Setting the thermostat 1°C higher than the desired temperature in the COOL mode and 2°C lower in the HEAT mode will save approximately 10 percent in power consumption. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. The temperature can be set within the range of 18 to 32°C. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature when the unit is turned on. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. To turn off the unit, press the ON/ OFF button again. ⷠThe red OPERATION lamp ( unit will turn off. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. The adjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for adjustment. [. . . ] hEAT MODE: · One hour after the timer operation begins, the temperature setting drops 3°C lower than the original temperature setting. The orange TIMER lamp ( ) on the unit will turn off. The unit will turn on automatically according to your setting. Timer duration can be set from a minimum of half an hour (30 minutes) to a maximum of 12 hours. [. . . ]