User manual SHARP AY-AP7FHR-WH

[. . . ] Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. [. . . ] Blocking direct sunlight during cooling operation will reduce power consumption. ⷠClose the windows and doors during cooling and heating operations. The indoor unit still consumes a small amount of power when it is not operating. NOTE: Actual units might vary slightly from those shown above. NOTE: Actual units might vary slightly from those shown above. Indicates when timer on or timer off is set. 1 Remove the battery cover at the back of the remote control. In 2 Insert batteries ± the compartment, making sure the and -- polarities are correctly aligned. ⷠLines will be indicated on the display when batteries are properly installed. The battery life is approximately one year in normal use. ⷠWhen you replace the batteries, always change both batteries, and make sure they are the same type. ⷠIf the remote control does not operate properly after replacing the batteries, press the RESET button using a thin stick. ⷠIf you will not be using the unit for a long time, remove the batteries from the remote control. Point the remote control towards the unit's signal receiver window and press the desired button. The unit generates a beep when it receives the signal. ⷠMake sure there is no curtain or other object between the remote control and the unit. ⷠThe remote control can send signals from up to 7 metres away. Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. ⷠUsing a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. [. . . ] 1 Make sure that the air filters are not dirty. The following conditions do not denote equipment malfunctions UNIT DOES NOT OPERATE The unit will not operate if it is turned on immediately after it is turned off. The unit will not operate immediately after the mode is changed. This is to protect the internal mechanisms. [. . . ]