User manual SHARP AY-XP12GR

[. . . ] Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. *) Please contact your local authority for further details. Attention: Your product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] 3 Push the arrow-marked of the panel firmly to lock it in place. 3 2 1 Precautions The filters are sealed in a plastic bag to keep their dust collection effect. Do not open the bag until using the filters. (Otherwise the filters life may get shorter. ) Do not expose the filters to direct sunlight. (Otherwise they may deteriorate. ) E-5 USING THE REMOTE CONTROL LOADING BATTERIES Use two size-AAA (R03) batteries. 1 Remove cover. the remote control Remote control cover batteries in 2 Insert making surethe compartment, the and -- polarities are correctly aligned. The display indicates "AM 6:00" when batteries are properly installed. the cover. + - 3 Reinstall + NOTES: The battery life is approximately one year in normal use. When you replace the batteries, always change both batteries, and make sure they are the same type. If the remote control does not operate properly after replacing the batteries, take out the batteries and reinstall them again after 30 seconds. If you will not be using the unit for a long time, remove the batteries from the remote control. HOW TO USE THE REMOTE CONTROL Point the remote control towards the unit's signal receiver window and press the desired button. The unit generates a beep when it receives the signal. Make sure there is no curtain or other object between the remote control and the unit. The remote control can send signals from up to 7 metres away. E-6 CAUTION Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. To turn off the PLASMACLUSTER lamp, press the DISPLAY button. When the PLASMACLUSTER button is pressed while the unit is not operating, the PLASMACLUSTER operation will be performed without accompanying air conditioning mode (eg, HEATING or COOLING). The mode symbol of the remote control will go off and the fan speed can not be set AUTO. 10C OPERATION Heating operation with 10C set temperature will be performed. AM 1 Press the MODE button and select HEAT mode. 2 Press the ON/OFF button to start HEAT operation. 3 Pressremote control will display 10C . The TO CANCEL 1h MODE CLEAN FAN SWING 1 Press the 10C button again. 10C operation will also be cancelled when the operation mode is changed, or when the unit is turned off. NOTE: 10C operation will not be available with heating operation automatically selected by AUTO mode. E-12 SELF CLEAN OPERATION SELF CLEAN operation will provide effect to reduce the growth mold fungus, and to dry inside of the air conditioner unit with Plasmacluster ions. This operation is accompanied by FAN or HEAT mode. Utilize the operation at seasonal change over terms. Mold fungus already grown can not be eliminated by this operation. 1 Press the SELF CLEAN button when the unit is not operating. The remote control displays " ". The blue PLASMACLUSTER lamp on the unit will light up. [. . . ] Condensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 percent. 20C D. B. = Wet-bulb This model is a Nordic version and designed for the Scandinavian climate condition. In the heating mode, lower limit temperature of outdoor side is -20C D. B. Cooling operation is available during the winter season by the built in winter cool function. [. . . ]