User manual SHARP AY-XP26FR-N

[. . . ] *) Please contact your local authority for further details. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. ⷠUsing a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. Example: 5 o'clock in the afternoon 1 To set to the 12-hour mode, press the CLOCK button once in the first step. 2 3 1 To set to the 24-hour mode, press the CLOCK button twice in the first step. The current time cannot be set when the timer is operating. The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. cOOL/HEAT MODE · The temperature can be set within the range of 18 to 32°C. Use of the PLASMACLUSTER operation will be memorized, and it will be activated the next time you turn on the air conditioner. When the PLASMACLUSTER button is pressed while the unit is not operating, the PLASMACLUSTER operation will be performed without accompanying air conditioning mode (eg, HEATING or COOLING). The mode symbol of the remote control will go off and the fan speed can not be set AUTO. SELF CLEAN operation will provide effect to reduce the growth mold fungus, and to dry inside of the air conditioner unit with Plasmacluster ions. Mold fungus already grown can not be eliminated by this operation. Press the SELF CLEAN button when the unit is not operating. The red OPERATION lamp ( ), the green SELF CLEAN lamp ( ) and the blue PLASMACLUSTER lamp on the unit will light up. ⷠThe unit will stop operation after forty minutes. Alternatively, turn the unit off by pressing the ON/OFF button. ⷠThe red OPERATION lamp ( ), the green SELF CLEAN lamp ( ) and the blue PLASMACLUSTER lamp on the unit will turn off. You cannot set the temperature, fan speed, air flow direction or timer setting during the SELF CLEAN operation. [. . . ] ⷠSetting the temperature lower than necessary during cooling operation will result in increased power consumption. Blocking direct sunlight during cooling operation will reduce power consumption. ⷠClose the windows and doors during cooling and heating operations. The indoor unit still consumes a small amount of power when it is not operating. [. . . ]