User manual SHARP AY-ZP40KR

[. . . ] *) Please contact your local authority for further details. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] Upper limit COOLING lower limit upper limit HEATING lower limit 32°C 21°C 27°C 46°C 21°C 24°C -7°C · The built-in protective device may prevent the unit from operating when used out of this range. ⷠCondensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 percent. This air conditioner has a memory function to store settings when a power failure occurs. After power recovery, the unit will automatically re-start in the same settings which were active before the power failure, except for timer settings. If the timers were set before a power failure, they will need to be re-set after power recovery. In the HEAT operation, the indoor fan may not start for two to five minutes after the unit is turned on to prevent cold air from blowing out of the unit. When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. During de-icing, the inside and outside fans stop operating. ⷠAfter de-icing is completed, the unit automatically resumes operation in the HEAT mode. The unit employs a heat pump that draws heat from the outside air and releases it into the room. The outside air temperature therefore greatly affects the heating efficiency. Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. ⷠUsing a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. The temperature can be set within the range of 18 to 32°C. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature when the unit is turned on. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. 5 To turn off the unit, press the ON/ OFF button again. [. . . ] The latest time setting will be memorized and will appear on the remote control display the next time you set the TIMER OFF or TIMER ON. While ONE-HOUR OFF TIMER is set, the TIMER OFF and TIMER ON setting are unavailable. In this operation, the air conditioner fan works at "extra high" speed with a setting temperature of 15°C in COOL and DRY modes and 32°C in HEAT mode to rapidly cool or heat the room. ) on the unit will light · TURBO operation will also be cancelled when the operation mode is changed, or when the unit is turned off. [. . . ]