User manual SHARP CD-CH1500W

[. . . ] Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. " Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. [. . . ] To remove the CDs: Whilst in the stop mode, press the desired " You can skip to any track by turning the jog dial until the desired track number appears. To restart the track being played: Turn the jog dial slowly anti-clockwise by one position during playback. After use: Press the ON/STAND-BY button to enter the power stand-by mode. Caution: " Do not place two CDs in one disc tray. " Do not push the disc tray whilst it is moving. " If the power fails whilst the tray is open, wait until the power is restored. " If the disc tray is stopped forcibly, "E-CD20" will appear in the display and the unit will not function. If this occurs, press the ON/STAND-BY button to enter the power stand-by mode and then turn the power on again. " If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. " If a disc is damaged, dirty, or loaded upside down, the disc will be skipped. " You can skip to any track by turning the jog dial until the desired track number appears. Notes: " You can locate the beginning of a track on a single disc only. " The or button on the remote control allows you to locate the beginning of a track. For audible fast forward: Press and hold down the button during playback. " When the end of the last track is reached during fast forward, "DISC END" will appear on the display and CD operation will be paused. To check which tracks are programmed: Whilst the unit is stopped in the programmed play mode, press the or button. Press the MEMORY button to save the track number. " Even if you press the ON/STAND-BY button to enter the stand-by mode or change the function from CD to another function, the programmed selections will not be cleared. " During programme operation, random play is not possible. Press the ON/STAND-BY button to turn the power on. 5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station. The reception changes to monaural, and the sound becomes clearer. [. . . ] ) or if it is operated incorrectly , it may malfunction. If such a problem occurs, do the following: 1 Set the unit to the stand-by mode and turn the power on again. 2 If the unit is not restored in the previous operation, unplug and plug in the unit, and then turn the power on. " Dirty heads, capstans or pinch rollers can cause poor sound and tape jams. [. . . ]