User manual SHARP CD-MPX100H

[. . . ] W sklad miniwiey CD-MPX100H wchodzi urzdzenie glówne (CD-MPX100H) oraz komplet kolumn (CP-MPX100H). A következ elemeket tartalmazza: CD-MPX100H (központi egység) és CP-MPX100H (hangszórórendszer). Minikomponentní systém CD-MPX100H se skládá z hlavní jednotky CD-MPX100H a systému reproduktor CP-MPX100H. Komponentový mikrosystém CD-MPX100H pozostávajúci z jednotky CD-MPX100H (hlavná jednotka) a CP-MPX100H (reproduktorový systém). [. . . ] For example, to choose 13 1 Press the "+10" button once. 2 Press the "3" button. To repeat a desired track: Perform steps 1 - 4 in the "Programmed play" section on page 17 and then press the / button twice. To cancel repeat play: Press the / button again. " " will go out. I Random play The tracks on the disc(s) can be played in random order automatically. Press the RANDOM button on the remote control to begin random play. CD or MP3/WMA disc Playback 5 2 3 4 5 6 7 8 B. For example, to choose 30 1 Press the "+10" button three times. Playback of the selected track is started. When the end of last track of the disc selected is reached, the next disc will be automatically started. Notes: G The selected track can be started simply by pressing the direct search buttons during playback. (It is not necessary to press the / button. ) G A track number higher than the number of tracks on the disc cannot be selected. G During random play, direct search is not possible. 3 To cancel random play: Press the / button. "NORMAL" will appear for 2 seconds. Notes: button during random play, you can move G If you press the to the track selected next by the random operation. On the other hand, the button does not allow you to move to the previous track. The beginning of the track being played will be located. G In random play, the unit will select and play tracks automatically. (You cannot select the order of the tracks. ) Caution: After performing repeat or random play, be sure to press the button. Otherwise, the disc(s) will play continuously. E-16 9/3/05 CD-MPX100H_2. fm TINSZA162AWZZ CD-MPX100H ENGLISH I Programmed play You can choose up to 32 selections for playback in the order you like. 1 Whilst in the stop mode, press one of the 1 - 3 buttons on the remote control to select the desired disc. Press the direct search buttons on the remote control to select the desired track. Selected disc number CD or MP3/WMA disc Playback 2 To clear the programmed selections: Whilst the "MEMORY" indicator is lit, set the stop mode and then press the CLEAR/DIMMER button. Each time the button is pressed, one track will be cleared, beginning with the last track programmed. When all the tracks are cleared, "MEMORY" indicator will disappear. Adding tracks to the programme: If a programme has been previously stored, the "MEMORY" indicator will be displayed. [. . . ] Note: If neither operation above restores the unit, clear all the memory by resetting it. ENGLISH I Condensation Sudden temperature changes, storage or operation in an extremely humid environment may cause condensation inside the cabinet (CD pickup, tape heads, etc. ) or on the transmitter on the remote control. Condensation can cause the unit to malfunction. If this happens, leave the power on with no disc (or cassette) in the unit until normal playback is possible (about 1 hour). Wipe off any condensation on the transmitter with a soft cloth before operating the unit. 1 2 Press the ON/STAND-BY button to enter the power stand-by mode. [. . . ]