User manual SHARP CDBA1500 OPERATION MANUAL

[. . . ] When the 12-hour display is selected, "AM" will change automatically to "PM". 0. 2 m - 6 m (8" - 20') Notes concerning use: Replace the batteries if the operating distance is reduced or if the operation becomes erratic. [. . . ] Periodically clean the transmitter LED on the remote control and the sensor on the main unit with a soft cloth. Exposing the sensor on the main unit to strong light may interfere with operation. Change the lighting or the direction of the unit. Keep the remote control away from moisture, excessive heat, shock, and vibrations. 7 Press the MEMORY/SET button. TUNING/TIME ( ) or ) button to adjust 1 RESETTING THE MICROCOMPUTER Press the ON/STAND-BY button to enter the standby mode. 8 Press the TUNING/TIME ( the minutes. 2 Press the CLOCK button. 3 ON/ STAND-BY EQUALIZER X-BASS/ DEMO Within 5 seconds, press the MEMORY/SET button. Press the TUNING/TIME ( or ) button once to advance the time by 1 minute. The time display will appear for about 5 seconds. "0:00" The 24-hour display will appear. (0:00 - 23:59) "AM 0:00" The 12-hour display will appear. (AM 0:00 - PM 11:59) Note: The clock display will flash on and off at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power lead is disconnected. If this happens, follow the procedure below to change the clock time. "AM 12:00" The 12-hour display will appear. (AM 12:00 - PM 11:59) Note that this can only be set when the unit is first installed or it has been reset. To change the clock time: 1 Press the CLOCK button. 2 Within 5 seconds, press the MEMORY/SET button. 3 Perform steps 6 - 9 above. 5 Press the MEMORY/SET button. To change the time display mode: 1 Perform steps 1 - 2 in "RESETTING THE MICROCOMPUTER". [. . . ] 2 Within 5 seconds, press the MEMORY/SET button. [. . . ]