User manual SHARP CD-BA2600H

[. . . ] Hänvisa till sidorna i till v och V-1 till V-35. Q Audio-visual material may consist of copyrighted works which must not be recorded without the authority of the owner of the copyright. Please refer to relevant law in your country. When the ON/STAND-BY button is set at STAND-BY position, the unit may be brought into operation by the timer mode or remote control. [. . . ] Emergency announcement made under exceptional circumstances to give warning of events causing danger of a general nature. Note: When you select a programme in the EON stand-by mode, the unit will display "TI" instead of "TA". Whilst in the ASPM operation mode, the tuner will automatically search for new RDS stations. If you have already stored some stations in memory, the number of new stations you can store will be less. The stations which are already stored in memory will be kept there. Z Any station which has the same frequency as the one stored in memory will not be stored. Z If 40 stations have already been stored in memory, the scan will be aborted. if you want to redo the ASPM operation , erase the preset memory. Z If no stations have been stored in memory, "END" will appear for about 4 seconds. Z If the RDS signals are very weak, station names may not be stored in memory. To erase all of the contents of preset memory: Press and hold down the ASPM button for at least 3 seconds. 1 Press the ON/STAND-BY button to enter the power stand-by mode. 2 Whilst pressing down the TUNER (BAND) button and the X-BASS/DEMO button, press the ON/STAND-BY button until "TUNER CL" appears. Z After performing this operation, all of the preset memory information will be erased. After "ASPM" has flashed for about 4 seconds, scanning will start (87. To store a station name again if the wrong name was stored in memory: It may be impossible to store station names in memory using the ASPM function if there is lots of noise or if the signal is too weak. 1 Press the PRESET or PRESET button to check whether the names are correct. 2 If you find a wrong name during receiving the station. Wait until the correct name will be displayed. 3 Within 30 seconds, press the MEMORY/SET button whilst the preset channel number is flashing. Z The new station name has been stored in memory correctly. When an RDS station is found, "RDS" will appear for a short time and the station will be stored in memory. [. . . ] Possible cause z Is the unit placed near the TV or computer? z Is the FM aerial or AM loop aerial placed properly?Move the AC power lead away from the aerial if located near. When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc. [. . . ]