User manual SHARP CDDP900 TAPE PLAYBACK AND TAPE RECORDING

[. . . ] Listening to a cassette tape (TAPE 1 or TAPE 2) Before playback: For playback, use normal or low-noise tapes for the best sound. (Metal or CrO tapes are not recommended. ) Do not use C-120 tapes or poor-quality tapes, as they may cause malfunctions. Before loading a tape into the cassette compartment, tighten the slack with a pen or a pencil. [. . . ] The volume and sound controls can be adjusted with no effect on the recorded signal (Variable Sound Monitor). Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback only. Recording from a CD (CDs) You can record 3 CDs continuously. 1 2 3 4 5 Press the ON/STAND-BY button to turn the power on. Load a cassette into the TAPE 2 cassette compartment with the side to be recorded on facing you. Wind past the leader of the tape, on which recording cannot be performed. Press the CD button and load the desired disc. Press the DISC SKIP button to select the disc to be recorded first. Press the REC PAUSE ( ) button. - Recording to a cassette tape - Tape Recording Recording will be paused. 6 Press the / (TAPE 2 ) button to start recording. CD playback will start approximately 7 seconds after the tape starts. Recording is started from the selected CD. When the playback of the last disc is finished or the end of the tape is reached, the CD and the cassette will stop automatically. To perform programmed recording: 1 2 3 Programme discs and tracks. (See page 18. ) Press the REC PAUSE ( ) button. Press the / (TAPE 2 ) button. To stop recording: Press the (CD ) button. The CD and tape will stop. Notes: When the end of the tape is reached whilst recording, the CD player will display the track number which was being played at that time, and stop automatically. If you want to restart recording from the beginning of the interrupted track, turn over the tape, press the REC PAUSE ( ) button and then the / (TAPE 2 ) button. (If tracks have been stored in memory by programming, recording will restart from the first track stored in memory. ) Whilst recording, OPEN/CLOSE button is deactivated. It is recommended to perform CD recording after closing the disc tray. 22 Programmed play (See page 18. ) 02/1/8 CD-DP900E(UK)_2. fm CD-DP900E Recording from the radio 1 2 3 4 Tune in to the desired station. [. . . ] TAPE 1 and TAPE 2 will simultaneously stop. Tab for side A Erasing recorded tapes 1 2 3 4 Load the tape to be erased into the TAPE 2 cassette compartment with the side to be erased facing toward you. Press the TAPE (1 2) button until "TAPE 2" appears on the display. Press the / (TAPE 2 ) button to start erasing. Note: Make sure that the TAPE 1 is not in use. Tuning (See page 19. ) 23 02/1/8 CD-DP900E(UK)_2. fm - Recording to a cassette tape - Tape Recording Press the / (TAPE 2 start recording. ) button to [. . . ]