User manual SHARP CMS/CP-R500/CDG

[. . . ] Warning: To prevent fire or shock hazard, do not expose this appliance to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the apparatus. CAUTION: At full power prolonged listening to a personal stereo may damage the user's hearing. The model is in compliance with the law in case of using it with the SHARP earphones (model number RPHOH0176AFSA). [. . . ] 0dB 4dB Adjust the recording level so that the maximum sound volume from the source makes the reading swing somewhere between ­4 dB and 0 dB. The track number will be increased by one each time you interrupt a recording. The unit automatically pauses when the microphone does not pick up any sound for 3 seconds or more. (Pause function does not work for approximately 10 seconds after a recording starts. ) When the microphone picks up sound again, recording starts automatically. Notes: q Whilst making a mic recording, do not connect anything to the OPTICAL/LINE IN socket on the portable MD. Q To use a microphone, be sure it is a plug-in-power type microphone. When a plug-in-power type microphone is plugged in, the portable MD will provide power for the microphone's operation. If a different type of microphone is plugged in, it may not operate properly or it may cause the unit to malfunction. If you don't, the recording will not be made properly. Q If the unit starts recording too often from low unwanted noises, set the microphone input to "MIC SYNC L". Recharge the battery or replace the alkaline battery with a new one. Q When the battery has run completely out, "BATT EMPTY (LoBATT)" will appear. Then, the power will be disconnected automatically. Notes: q If you use the battery which you stopped charging halfway, " " may appear. It does not mean that the battery is completely charged. Q The battery indicator will not correctly display the remaining capacity for approximately 20 seconds after the power has been turned on. Q When the AC adaptor or a separately available car adaptor is used, the battery indicator will not be shown. Q The number of bars shown in the battery indicator may increase or decrease, depending on the operation being performed. MENU BEEP ON Confirmation sound A-PLAY ON Auto play AUTO Psave Auto power save D. With a MiniDisc inserted, press the MODE button for 2 seconds or more. You can eliminate the confirmation sound that beeps when you press a button. [. . . ] clean the plugs and the connecting socket. If the plugs or sockets are dirty, noise may be heard. When the unit has condensation inside, the disc signals cannot be read, and the unit may not function properly. In the following cases, condensation may form inside the unit. [. . . ]