User manual SHARP CP-R600

[. . . ] This unit should only be used within the range of 5°C - 35°C (41°F - 95°F). The apparatus is designed for use in moderate climates. Warning: The voltage used must be the same as that specified on this unit. Using this product with a higher voltage other than that which is specified is dangerous and may result in a fire or other type of accident causing damage. [. . . ] Do not touch the warm areas of the unit for prolonged periods to avoid injury. Volume control The sound level at a given volume setting depends on speaker efficiency, location, and various other factors. It is advisable to avoid exposure to high volume levels. Do not turn the volume on to full at switch on. Listen to music at moderate levels. E-2 General Information CP-R600 Controls and indicators Front panel Reference page 1. 7 ENGLISH 1 2 3456 Rear panel Reference page 1. 5 General Information Remote control 123 1 2 4 Reference page 1. 8 TV Operation Buttons (Only SHARP TV): On/Stand-by Button Sets the TV Input Select power to Button (TV) "ON" or "STAND-BY". Channel Up and Down Buttons Press the button to switch the input source. Switch up/ down the TV channels. Remote control Plastic shield 3 Battery holder Volume Up and Down Buttons E-3 Note: Before using remote control, please remove plastic shield at battery holder. Note: Some models of SHARP TV may not be operable. Subwoofer preparation Make sure to unplug the AC power lead before installing the main unit or changing the position. Select from three installation methods according to the preferred position. Horizontal position Using spikes Placing the subwoofer Installation image: TV CP-R600 ENGLISH VCR DVD player DVD player 1 Tighten all spikes as shown Notes: When attaching the spikes, place the subwoofer on a cushion or soft cloth to avoid damage. The subwoofer can be leveled by adjusting the spikes. 2 Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control. Battery holder Positive (+) side up Polarity (+) symbol Battery type Locking tab Precautions for battery use: Remove the battery if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage. Caution: Do not use rechargeable battery (nickel-cadmium battery, etc. ). Replace only with the same or equivalent type. Installing the battery incorrectly may cause the unit to malfunction. Danger of explosion if battery is incorrectly replaced. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. E-6 Preparation for Use CP-R600 Remote control (continued) Notes concerning use: Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase "CR 2025", coin lithium battery. Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs. [. . . ] (TV) Note: Some models of SHARP TV may not be operable. In this case, use the remote control supplied with each product. E-8 Advanced Feature Adjust the high frequency cut-off point. Frequencies higher than the set frequency are removed. To emphasise the bass, turn this control towards 80 Hz and increase the volume. CP-R600 Troubleshooting chart Many potential problems can be resolved by the owner without calling a service technician. [. . . ]