User manual SHARP CP-C260H

[. . . ] Preparation Using with the Rechargeable Battery. 11 - 12 Wearing the Earphones (ear-fit type) . 24 My Entry Playback (favourite track playback) . 13 Long Time Recording and Group Recording . [. . . ] Press the GROUP button. -Recording from a Microphone- To write recorded contents on the MiniDisc Press the Notes: " Whilst making a mic recording, do not connect anything to the OPTICAL/LINE IN socket on the portable MD. " To use a microphone, be sure it is a plug-in-power type microphone. - When a plug-in-power type microphone is plugged in, the portable MD will provide power for the microphone's operation. - If a different type of microphone is plugged in, it may not operate properly or it may cause the unit to malfunction. If you don't, the recording will not be made properly. " Use a microphone with a 3. 5 mm (1/8") diameter stereo mini plug. Group recording will be activated. Useful Features Press the GROUP button. GROUP1 1 2 1 2 3 A B C D E The track numbers will also be changed. For group recording, see page 14. E-37 02/12/18 MDDR470_SEEG_E. fm CP-C260HH ENGLISH !Sound-actuated recording (Mic Synchronised recording) The unit automatically pauses when the microphone does not pick up any sound for 3 seconds or more. (Pause function does not work for approximately 10 seconds after a recording starts. ) When the microphone picks up sound again, recording starts automatically. Cancel the setting for trace-back recording. 7 8 9 Press the MENU button. The unit enters the menu select mode. Select "SYNC REC" by pressing the or button and press the MENU button. 1 2 Press the REC button. Recording is paused. To perform group recording, hold down the GROUP button for 2 seconds or more so that "GR" is lit. When group recording is not performed, hold down the GROUP button for 2 seconds or more so that "GR" goes out. 3 4 5 6 Press the or level (page 17). button to adjust the recording MIC SYNC H (High): Recording starts when the unit detects -24 dB or more (the unit can start recording from quiet sounds). MIC SYNC L (Low): Recording starts when the unit detects -12 dB or more. " When the battery has run out completely, "BATT EMPTY" will appear. Then, the power will be disconnected automatically. Notes: " If you use the battery which you stopped charging halfway, " " may appear. It does not mean that the battery is completely charged. " The battery indicator will not correctly display the remaining capacity for approximately 20 seconds after the power has been turned on. " When the AC adaptor or a separately available car adaptor is used, the battery indicator will not be shown. " The number of bars shown in the battery indicator may increase or decrease, depending on the operation being performed. This is normal. E-42 02/12/18 MDDR470_SEEG_E. fm -Checking Displays- button. Useful Features [On the main unit] Select a track by pressing the CP-C260HH Titling a MiniDisc " Load a MiniDisc to be named. A playback only or recording prevented MiniDisc cannot be edited. " The group-recorded MD may not be edited properly with other equipment. Editing can be done only on the main unit. ENGLISH 5 When "DISC NAME" appears, press the MENU button. [. . . ] " The write protection tab of a MiniDisc is set to the protected position. " Cannot operate this unit whilst searching/updating groups and track numbers. (Wait for a while and try the operation again. ) ERROR MESMEANING SAGES TOC FORM " There is an error in the recording signal. (**) (Erase all of the tracks, and then record again. ) TOC FULL (T-FULL) TEMP OVER Tr. [. . . ]