User manual SHARP CV-3720G

[. . . ] SERVICE (for your nearest Sharp Authorized Servicer) PARTS (for your Authorized Parts Distributor) ACCESSORIES ADDITIONAL CUSTOMER INFORMATION TO WRITE: For service problems, warranty information, missing items and other assistance: Please provide the following information when you write or call: model number, serial number, date of purchase, your complete mailing address (including zip code), your daytime telephone number (including area code) and description of the problem. USERS SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. This warranty does not apply to any appearance items of the Product nor to the additional excluded item(s) set forth below nor to any Product the exterior of which has been damaged or defaced, which has been subjected to improper voltage or other misuse, abnormal service or handling, or which has been altered or modified in design or construction. In order to enforce the rights under this limited warranty, the purchaser should follow the steps set forth below and provide proof of purchase to the servicer. [. . . ] Connect the rain guards to the insect guard net. Insert all three projections on each rain guard into the holes in the insect guard net. 2 Attach the guard combined above to the window panel. Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel. Side "A" will now be at the top, as indicated in the diagram, when it is installed in the window. The foam seal to 3 Cut proper length A (adhesive ittype)the the and attach to window frame. 4 Install the window panel into the window frame. If the inner height of the window is between 22" (559mm) and 24" (609mm) inclusive. The window panel cannot be installed in windows less than 22" (559mm) high, as you will be unable to shut the exhaust cover. (1) Remove the adjustment panel from the window panel, and cut the window panel to the same height as the window. (2) Open the window sash and place the window panel on the window frame. Protect the remote control from moisture and shock which can discolor or damage it. To prevent the remote control from being misplaced, hook it to the unit when not in use. When attached, to remove the remote control from the unit, lift the remote control up slightly and pull it out. Install the exhaust hose (See Page14), turn the drainage nozzle to the CLOSE position, "CLOSE" position and check the drainage nozzle is covered with the stopcock. Ensure that the stopcock is securely inserted into the lower drainpipe nozzle and that the nozzle has not been damaged. The temperature can be set within the range of 64°F to 86°F. The red OPERATION lamp on the unit will turn off. Ensure that the stopcock is securely inserted into the lower drainpipe nozzle and that the nozzle has not been damaged. Pull the stopcock out from the drainage nozzle. When the stopcock is removed, a small amount of water may be discharged from the drainage nozzle. Always perform this procedure with the unit turned off. [. . . ] Never use harsh chemicals or abrasive cleaners on any part of the unit. To avoid damaging the unit, do not use hot water (120°F/50°C or hotter) when cleaning. The cooling performance may be reduced or stop completely if the insect guard net becomes clogged with dust. Periodically remove the window exhaust adapter from the window panel and clean the insect guard net with a vacuum cleaner. [. . . ]