User manual SHARP CV-P09FR

[. . . ] Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. [. . . ] Use of a fluorescent lamp in the same room may interfere with transmission of the signal. The unit may be affected by signals emitted from other remote controllers for televisions, VCRs or other equipment used in the same room. Do not leave the remote control exposed to direct sunlight or near a heater. Protect the remote control from moisture and shock which can discolor or damage it. To prevent the remote control from being misplaced, hook it to the unit when not in use. When attached, to remove the remote control from the unit, lift the remote control up slightly and pull it out. The exhaust hose must be installed or removed in accordance with the usage mode. Push the insect guard net firmly to ensure that four projections on the exhaust adapter fit into the four holes on it. Extend one end of the exhaust hose and insert it into the Exhaust adapter, and turn it (approx. Make sure they are securely attached afterwards. Insert the two projections on the exhaust hose adapter into the two holes on the unit, and firmly attach them to each other. Suction disk may be used to keep window or door closed. The exhaust hose should be as short as possible for operational efficiency; however, it must not be twisted or bent. Lift up and remove the exhaust hose adapter from the unit by pushing down on the two projections. Install the exhaust hose (See Page 8), turn the drainage nozzle to the CLOSE position, and check the drainage nozzle is covered with the stopcock. The temperature can be set within the range of 18°C to 32°C. Pull the stopcock out from the drainage nozzle. When the stopcock is removed, a small amount of water may be discharged from the drainage nozzle. Always perform this procedure with the unit turned off. Drain water will spout out if attempted during operation. Depending on room condition, approximately 28 liters of water per day (24 hours) will be dehumidified. Prepare some kind of bucket of appropriate size to collect drain water, or take some appropriate measure to drain the water outside of the room, so that drain water will not overflow or soak your room. [. . . ] Did you restart the unit within 3 minutes of a power failure?If the power was off for less than 3 minutes when, you restarted the air conditioner, a protective device may cause the compressor to shut off, preventing cooling for about 5 minutes. Cooling does not take place in these modes. Run the air conditioner in FAN mode with the fan speed set to "HIGH" until all ice dissipates. [. . . ]