User manual SHARP DV-HR450F

[. . . ] Is the signal emitter on the Remote pointing at the Unit?Is the Remote too far from the Unit, or is there any obstacle between the Remote and the Unit?· Did the VCR/DVD CHANGE Switch change correctly?· Did the VCR/DVD SELECTOR change correctly? [. . . ] · The video heads may have been contaminated - refer to a SHARP Service Facility. · Ensure the VCR is connected to a stereo TV with a SCART lead. · Programme may not carry stereo. OTHER INFORMATION · Playback/Recording does not play back in Stereo. 96 DVNC60H(E)#096_101. pm6 Web-site:www. sharp. co. uk/support Help line:08705 274277 (office hours) 96 19/09/2001, 14:29 Troubleshooting Problem · Tape is automatically ejected when pressing ÆREC or TIMER ON/OFF. · VIDEOPLUS+ does not record desired programme. Possible Cause/Solutions · The record-protection tab has been removed from the cassette. · Broadcast does not carry VPS/PDC signal which alters recording time. · Check VPS/PDC mode is switched ON. · Ensure date and time are correctly set on the Unit. · Make sure there is no other tape in the VCR. · Make sure you are loading the tape correctly. · Make sure the tape is not at the start. · The channel position has been set to be skipped. Its performance could be adversely affected by external electrical noise or interference. If this should happen, unplug the Unit and plug it in again after a few minutes. Web-site:www. sharp. co. uk/support Help line:08705 274277 (office hours) DVNC60H(E)#096_101. pm6 97 19/09/2001, 14:29 97 Definition of Terms I VCR Full Automatic Playback Sharp Super Picture S-VHS Simple Playback Tracking Control This function automatically turns the power on and starts to playback when a tape with the erasure protection tabs removed is inserted. Enhanced picture quality during playback. This function facilitates S-VHS software playback. The original high picture quality of SVHS (horizontal resolution of 400 lines) cannot be played. When noise appears on an image during tape playback, you can adjust the image quality to a suitable level so as to reduce the noise. I DVD Angle Recorded onto some DVD discs are scenes which have been simultaneously shot from a number of different angles (the same scene is shot from the front, from the left side, from the right side, etc, ). With such discs, you can select the angle on Function Control Screen to view the scene from different angles. These numbers are recorded on DVD discs. A title is subdivided into many sections, each of which is numbered, and specific parts of video presentations can be searched quickly using these numbers. Setting that increases the average volume of Dolby Digital audio when playing a DVD. Chapter Number Compression (Dolby Digital output level) Digital Gamma Digital Super Picture Dolby Digital (5. 1 channel) Virtual Dolby (QSURROUND) DTS Corrects for gradations in dark areas of images to make images clearer. Enhances the fine detail of the image and outlines of the objects it contains. A sound system developed by Dolby Laboratories Inc. that gives movie theater ambience to audio output when the DVD video player is connected to a Dolby Digital 5. 1 channel processor or amplifier. [. . . ] Screen size that cuts off the top and bottom of the image to allow playing of Wide (16:9) software on a connected 4:3 TV. Linear PCM is a signal recording format used for audio CDs. The sound on audio CDs is recorded at 44. 1 kHz with 16 bits. (On DVD discs, sound is recorded at between 48 kHz with 16 bits and 96 kHz with 24 bits. ) Screen size that cuts off the sides of the image to allow playing of Wide (16:9) software on a connected 4:3 TV. [. . . ]