User manual SHARP DV-NC100S(Y)

[. . . ] VCR/DVD COMBINATION MODEL DV-NC100S(Y) OPERATION MANUAL Please read this Operation Manual carefully before using your VCR/DVD COMBINATION. DV-NC100 OPERATE OPEN/CLOSE PULL OPEN REW FF STOP/ EJECT OUTPUT PLAY REC TIMER CH VCR DVD STOP PLAY (TRACKING) 2 The region number for this VCR/DVD is 2. SHOWVIEW is a registered trademark of Gemstar Development Corporation. The SHOWVIEW system is manufactured under licence from Gemstar Development Corporation. SAFETY INFORMATION WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, AND ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPARATUS TO DRIPPING OR SPLASHING, NO OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHOULD BE PLACED ON THE APPARATUS. [. . . ] 5 Press K or L repeatedly until the desired tape speed appears. 6 Press K or L to set VPS/PDC ON or OFF. 8 Press TIMER ON/OFF to activate the timer. The TIMER indicator on the VCR/DVD comes on. in the normal mode (without VPS/PDC) even if it was programmed for VPS/PDC. When the starting time of the VPS/PDC timer recording is from 0:00 to 3:59 on a given day, the VPS/PDC function operates from 20:00 on the previous day to 4:00 on the following day. When the starting time of the VPS/PDC timer recording is from 4:00 to 23:59 on the given day, the VPS/PDC function operates from 0:00 on the day to 4:00 on the following day. This means that if the relevant programme is broadcasted within this period, it will be recorded correctly. If the timer is not programmed correctly, the incorrect timer setting stays in effect unless you cancel it. To cancel the incorrect timer setting, refer to "To Cancel or Check the Start/End Time" on page 17. Quick-Find This function enables you to search and confirm the contents of the recorded programme(s) using the index mark. · The tape must be fully rewound. To skip to the beginning of next programme Press QUICK-FIND. NOTES: · This function will not operate in the Recording mode. · When you want to cancel the Quick-Find while in progress, press STOP. · When the end of a tape is reached during the QuickFind, the tape will automatically rewind to the beginning. After rewinding finishes, the VCR/DVD will eject the tape. Index Search · The index mark will be made automatically when REC/OTR is pressed. It will also be marked at the starting point of Timer recording and OTR. · The index mark is not recorded if STILL/PAUSE is pressed and released during recording. · The time gap between index marks on the tape should be greater than 1 minute for SP recording and 2 minutes for LP recording. 2 Press K or L repeatedly until the number of programmes that you want to skip appears. The VCR/DVD begins rewinding or fast forwarding to the beginning of desired programme. · When the preset programme is reached, the VCR/DVD will start playback automatically. [. . . ] VCR/DVD cannot not read CDs/DVDs ­Use a commonly available cleaning CD/DVD to clean the lens before sending the VCR/DVD for repair. ­Make sure the tape has a erase-prevention tab. ­Make sure this VCR/DVD is in VCR mode. The VCR does not perform a timer recording. [. . . ]