User manual SHARP DX-612H

[. . . ] UP: This function will increase the track number by one. DOWN: This function will decrease the track number by one. PLAY: Pressing this will set the Product 8 Transport in the play mode. STOP: Pressing this function will cancel any function or command that the Product 8 CD Player is currently performing. [. . . ] Pressing this function twice will also cancel any program sequence that is outstanding. OPEN/CLOSE: This function, when pressed for the first time, will open the CD drawer and allow you to load your CD disc. Pressing this function again will load the CD disc into the Product 8 CD Player. POWER: This will either fully power up the Product 8 CD Player or be completely switched off. scan repeat displ REMOTE HANDSET The Product 8 CD Player supplies with a full function handset. It needs two R03 AAA 1. 5V batteries to operate and the functions are as follows: Power Standby (not used on the Product 8 CD Player) prog clear check a+b shuffle displ prog clear check a+b shuffle Toggles the LCD display brightness, on/medium/off Program button Delete a programmed track Check programmed tracks Repeat a session of a track from a specific point to another Random play Open/Close the CD drawer Search up KEYPAD Search down Stop 1 4 7 2 5 8 0 3 6 9 scan space Track up Track down Play Pause Scan all the tracks on the CD with 10 sec. intro Repeat all the tracks or a single track Toggles between the elapsed or the remaining time of a track or the CD Add 4 sec. in-between tracks time repeat mute vol+ vol- time space volvol+ mute (not used on the Product 8 CD Player) (not used on the Product 8 CD Player) (not used on the Product 8 CD Player) NORMAL PLAY Switch the Product 8 CD Player `on', then press the `open/close' button to open the drawer. Load the CD and press the `open/close' again to close the drawer. Press `Play' to begin. REPEAT PLAY Press `repeat' the first time will play all the tracks in the CD or a program again after they have been played. Please note: As this player has been designed to incorporate all of today's latest technologies, the two digital outputs are configured to provide a 96KHz signal only. This will prove incompatible with any DAC that uses the older 48KHz signal. GENERAL CAUTIONS FCC Warning. The Product 8 CD Player may use or generate radio frequency. Please note that, if any unauthorised modifications are made, the user may loose the right to operate this equipment. If installed properly, the Product 8 CD Player should not cause harmful interference to radio communications. However, there is no guarantee that, in certain installations, such interference will not occur. If interference does arise (and this can be determined by switching the unit off and on), then try the following: 1, Increase the distance between the offending units 2, Connect the Product 8 CD Player to a different mains supply to that of the affected unit. 3, For further advise or help please consult your dealer or an appointed engineer. Please note: that when the cover of the Product 8 CD Player has been removed there may bee some stray invisible radiation from the laser assembly. [. . . ] Please note: that when the cover of the Product 8 CD Player has been removed there may bee some stray invisible radiation from the laser assembly. Never look directly into the exposed beam. GENERAL CARE Any cleaning of your DX-612H Player should be done with a clean dry cloth or soft bristle brush. There is no need to polish the gold effects, a simple dry wipe is sufficient. Do not use any solvent or silicone based cleaning solutions as this may result in tarnishing. [. . . ]