User manual SHARP EBR-47ST

[. . . ] Disconnect the oven from the power supply before installation. Make sure that the EBR-47ST is the correct surround for your oven. The Sharp Microwave Ovens are designed to either stand neatly on a kitchen counter top or to be built into a fitted kitchen cabinet using the surround. [. . . ] The mains plug must be accessible after instalation or an all-pole switch disconnection must be provided with a contact separation of at least 3 mm in each pole. (For Continental use) The electric outlet must be installed at 150 mm high from the floor of the built-in cabinet and at 50 mm from the right wall of the built-in cabinet as shown in Fig. The mains plug must be accessible after installation or the oven must be connected to an electric circuit provided with an all-pole switch (contact gap no less than 3 mm) to disconnect the oven in case of danger. A safety-device like a fuse in the installation may be used as a switch. Caution: Make sure that the oven always keeps its balance to avoid falling over. Attach the aluminium sheet C onto the back panel D of the built in cabinet as shown in Fig. And set the spacing brackets 1 on the shelf along the right and left walls of the kitchen cabinet, keeping a distance of 17 mm between the front end of the shelf and the spacing brackets, and attach them with the four screws 0, as shown in Fig. Caution: The arrow marks on each spacing bracket should be pointing towards you. Insert two tabs of the intake duct 3 into the slits of the back plate E. And install the intake duct 3 to the back plate E with one screw A as shown in Fig. Loosen one screw F holding the outer wrap to the rear of the oven as shown in Fig. Install the exhaust duct 2 to the rear of the oven by tightening two screws A and F (loosend at step 6) as shown in Fig. Loosen the one screw G holding the back plate E to the rear of the oven as shown in Fig. Remove the one screw H from the oven as shown in Fig. [. . . ] And secure the built-in frame element 8 through the holes of the built-in frame side elements 9 to the kitchen cabinet with two screws B as shown in Fig. 9, or the kitchen cabinet door may touch the built-in frame elements. Fixer le support 6 au sommet du conduit d'aspiration 4 et à sa gauche et fixer le support 7 à la gauche du support 6 et du four, comme le montrent les figures 6-a et 6-b. [. . . ]