User manual SHARP EL-2607PC

[. . . ] The count is printed when the calculated result is obtained. 2) When the grand total/rate setting mode selector is in the ON position (GT), the counter will count the number of times that the calculation results have been stored in the grand total memory. To print and clear the count, press the key. 3) The memory item counter will count the number of times that the key has been pressed in the addition. [. . . ] note: · Be sure to set this selector to the "· " position after storing an each rate. If you enter a new rate, the previous rate will be cleared. MULTIPLICATION KEY DIVISION KEY MINUS EQUAL KEY PLUS EQUAL KEY CHANGE SIGN KEY MARKUP KEY MEMORY TOTAL CLEAR KEY MEMORY SUBTOTAL RECALL KEY MEMORY PLUS KEY MEMORY MINUS KEY CONVERSION KEY (TO A NATIONAL CURRENCY) CONVERSION KEY (TO THE EURO CURRENCY) PERCENT KEY NON-ADD/SUBTOTAL KEY: Non-add ­ When this key is pressed right after an entry of a number in the Print mode, the entry is printed on the left-hand side with the symbol "#". This key is used to print out numbers not subjects to calculation such as code, date, etc. subtotal ­ Used to get subtotal(s) of additions and/or subtractions. When pressed following the or key, the subtotal is printed with the symbol "" and the calculation may be continued. By pressing this key even in the Non-print mode, the displayed number is printed with the symbol "P". : Appears when a number is in the grand total memory. * Although all available symbols are shown here for instruction purposes, these symbols will not appear on the screen simultaneously. Remove the paper roll from the calculator. (Tear the paper and remove it from the print mechanism by using . Turn the power off before replacing ribbon. Thread the ribbon around the outside of the metal guides. Take up any slack by manually turning one of the reels. Always cut leading edge with scissors first. 1) Insert the leading edge of the paper roll into the opening. 1) 2) Turn the power on and feed the paper by pressing . 2) 3) Insert the paper roll to the paper holder. There are several situations which will cause an overflow or an error condition. when this occurs , "E" will be displayed. [. . . ] Keep the unit unplugged for about 5 seconds, reconnect the AC plug, then turn on the power. The rounding selector should be in the "5/4" position unless otherwise specified. The print/item count mode selector should be in the "P" position unless otherwise specified. If an error is made while entering a number, press or and enter the correct number. [. . . ]