User manual SHARP EL2196BL

[. . . ] WARNING ­ FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] First, pull out the insulation sheet for the memory protection battery (installed for retaining the date/time/tax rate information). Reset the calculator to initialize the unit's state, then adjust the date and time before using the calculator. Pull out the insulation sheet for the memory protection battery. Always cut leading edge with scissors first. 1) Insert the leading edge of the paper roll into the opening. 1) 2) Turn the power on and feed the paper by pressing (Fig. 2) 3) Insert the paper roll to the paper holder. (see "GRAND TOTAL / RATE SETTING MODE SELECTOR") * When the adjustment is complete, the clock starts at 3:38:00 p. Each time this key is pressed, the mode switches. There are several situations which will cause an overflow or an error condition. when this occurs , "E" will be displayed. The contents of the memory at the time of the error are retained. If an ``0 E'' is displayed at the time of the error, must be used to clear the calculator. If an ``E'' with any numerals except zero is displayed, the error may be cleared with or and the calculation can still be continued. also , in rare cases , printing may stop midway and the indication "E" appear on the display. This is not a malfunction but is caused when the calculator is exposed to strong electromagnetic noise or static electricity from an external source. Should this occur, press the key and then repeat the calculation from the beginning. 1) The counter will count the number of times that the key has been pressed in addition. note: · Each time the key is used in subtraction, 1 will be subtracted from the count. The count is printed when the calculated result is obtained. 2) When the grand total/rate setting mode selector is in the ON position (GT), the counter will count the number of times that the calculation results have been stored in the grand total memory. To print and clear the count, press the key. [. . . ] The socket outlet shall be installed near the equipment and shall be easily accessible. SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. This warranty does not apply to any appearance items of the Product nor to the additional excluded item(s) set forth below nor to any Product the exterior of which has been damaged or defaced, which has been subjected to improper voltage or other misuse, abnormal service or handling, or which has been altered or modified in design or construction. In order to enforce the rights under this limited warranty, the purchaser should follow the steps set forth below and provide proof of purchase to the servicer. [. . . ]