User manual SHARP EL2630PIII

[. . . ] To recall the presently stored rate for first to clear the check. Press calculation register and reset an error condition, then press . the conversion rate is printed with the symbol "#". CONVERSION KEY: This key is used to obtain a value by dividing a given number with a specified conversion rate. [. . . ] Note: The decimal point floats during successive calculation by the use of or . If the decimal selector is set to "F" then the answer is always rounded down ( ). Cleaning the printing mechanism If the print become dull after long time usage, clean the printing wheel according to the following procedures: 1) Remove the printer cover and the ink roller. 2) Install the paper roll and feed it until it comes out of the front of the printing mechanism. 3) Put a small brush (like a tooth brush) lightly to the printing wheel and clean it by pressing . Never attempt to turn the printing belt or restrict its movement while printing. Do not rotate the printing mechanism manually, this may damage the printer. ": Neutral STORE KEY: This key is used to store the conversion rate or the tax/discount rate. conversion rate: · Enter the conversion rate, then press . A maximum of 6 digits can be stored (decimal point is not counted as a digit). tax/discount rate: · Enter the adding tax rate, then press . If such abnormal conditions are observed, unplug the AC cord from the socket. Keep the unit unplugged for about 5 seconds, reconnect the AC plug, then turn on the power. The rounding selector should be in the ``5/4'' position unless otherwise specified. The print/item count mode selector should be in the " If an error is made while entering a or and enter the number, press correct number. Negative values are printed with ``­'' symbol in red. *: Press to clear the memory before starting a memory calculation. Accessories, and additional Sharp Products can be purchased from the Authorized Sharp Reseller where you purchased your product or on-line at: SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. This warranty does not apply to any appearance items of the Product nor to the additional excluded item(s) set forth below nor to any Product the exterior of which has been damaged or defaced, which has been subjected to improper voltage or other misuse, abnormal service or handling, or which has been altered or modified in design or construction. In order to enforce the rights under this limited warranty, the purchaser should follow the steps set forth below and provide proof of purchase to the servicer. The limited warranty described herein is in addition to whatever implied warranties may be granted to purchasers by law. aLL IMPLIED WARRANTIES INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR USE ARE LIMITED TO THE PERIOD(S) FROM THE DATE OF PURCHASE SET FORTH BELOW. [. . . ] If any such defects should be found in this product within the applicable warranty period, Sharp shall, at its option, repair or replace the product as specified herein. This warranty shall not apply to: (a) Any defects caused or repairs required as a result of abusive operation, negligence, accident, improper installation or inappropriate use as outlined in the owner's manual. (b) Any Sharp product tampered with, modified, adjusted or repaired by any party other than Sharp, Sharp's Authorized Service Centres or Sharp's Authorized Servicing Dealers. (c) Damage caused or repairs required as a result of the use with items not specified or approved by Sharp, including but not limited to software, paper and batteries. [. . . ]