User manual SHARP ERA330 BROCHURE

[. . . ] (1) Creating the master list (subwindow program) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (2) Deleting a machine from the master list (subwindow program). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Specifying the terminal to serve as a backup master -- master . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Specifying whether to enable or disable the system retry function when a transmission error occurs -- master and satellite . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · For the clerk entry key system: Press the clerk entry key that you pressed to sign on, again. · For the WMF clerk key system: Pull out the inserted clerk key. · For the clerk code entry system: Press only the CLK key. # NOTE · The sign-off operation can be made only for one clerk at a time. · If a clerk signs on at a machine while another clerk has already signed on there, the latter is automatically signed off. 31 6. Clerk system In the IRC system, the following two types of clerk file allocation systems are available: a centralized system and an individual system. In the centralized file allocation system, the master manages transaction data on clerks in the IRC system. In the individual file allocation system, each machine manages clerk transaction data in it. For selection of the file allocation system, contact your SHARP dealer. (1) Centralized file allocation system In this system, each clerk file is under the centralized control of the master and programming for clerks has to be done only at the master. When a programmed clerk is signed on at a satellite, a communication between the satellite and the master will begin. You can generate a report which lists clerks signed on. Automatic look-up As drive-through codes are temporarily finalized by pressing the NBAL or FINAL key, data for these codes is automatically looked up in the same sequence as the code was generated. Drive-through-related inline communications are made for the following purposes: · · · · · New order or re-order Payment entry or temporary finalization Slip printing Bill transfer/bill totalizing Bill separating The drive-through data is transmitted from the master to a satellite for drive-through file look-up (in case of a new order/re-order). In this case, the drive-through reserve counter is retained at the master. The data is transmitted from a satellite to the master for finalization of a transaction (in case of a payment entry or temporary finalization). The data transmitted from the satellite is once saved in the drive-through data receiving file and then in the drive-through file. In this case, the drivethrough reserve counter is cleared at the master. 35 10. T-LOG polling All REG-mode transaction data in each satellite is saved in its T-LOG buffer. T-LOG polling is a data collecting system in which the master collects data from the T-LOG buffers in satellites. T-LOG polling becomes available upon open-store operation and becomes unavailable upon close store operation. A request for T-LOG polling is issued from the satellite to the master when the number of data records in its T-LOG buffer exceeds a certain number in the open store state. As the master detects such a request, it starts collecting T-LOG buffer data. [. . . ] Pull up the ribbon cover and remove it. 2. Rotate the take-up knob of the ink ribbon cassette in the direction of the arrow to tighten the ink ribbon. Ink ribbon cassete Take-up knob 3. Push the ink ribbon cassette to the left, then lift up its right side to remove it. 4. Rotate the take-up knob of the new ink ribbon cassette to tighten the ink ribbon. [. . . ]