User manual SHARP FO-100

[. . . ] 6 seconds (only when ECM is on) Horizontal: 8 pels/mm Vertical: Standard: 3. 50 Letter/A4 sheets (at room temperature; maximum stack height should not be higher than the line on the tray) Legal: 5 sheets Applicable telephone line Public switched telephone network Compatibility Input document size ITU-T (CCITT) G3 mode Automatic feeding: Width: 148 to 216 mm Length: 140 to 297 mm Manual feeding: Width: 148 to 216 mm Length: 140 to 600 mm 210 mm max. Single / Multi (99 copies/page) Yes (cannot be used if power fails) 220 - 240 V AC, 50/60 Hz 5 - 35°C 25 - 85% RH Standby: 2. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. [. . . ] Use SUPER FINE for documents containing very small letters or very fine drawings. The document must be loaded before Press RESOLUTION one or more times until the desired resolution and contrast settings appear in the display. The first time you move through the list Of resolution settings, the contrast setting AUTO will appear next to each resolution setting. The second time you move through the list, the contrast setting DARK will appear. Note: In order to transmit in SUPER FINE resolution, the receiving fax machine must also have that resolution. If it doesn't, your machine will automatically step down to the next best available setting. With Normal Dialling, you pick up the handset (or press pressing the number keys. If a person answers, you can talk with them through the handset before sending the fax. (If you pressed , you must pick up the handset to talk. Normal Dialling allows you to listen to the line and make sure the other fax Dial the number of the receiving machine by pressing the number keys. Depending on the setting of the receiving machine, you will either hear a fax tone or the other person will answer. Until the number you wish to edit or clear appears in Return to Step 2 to edit or clear another number, or press return to the date and time display. Using an auto-dial number Once you have stored a fax or phone number, you can use it to send a fax or make a phone call. If you are sending a fax, load the document(s). Press (or ) until the name of the other party appears in the display (if no name was stored, the number will appear). Report to inform you of the problem (see page 78). If you are making a phone call, lift the handset. You can also enter a full number with the number keys and then press the You can use this method to dial a full Number when you don't need to speak to the other party before faxing. Enter the number of the receiving machine by pressing the number keys. If a pause is required between any of the digits to access a special service Several pauses can be entered in a row. If the number of the receiving machine shown is correct, press If the number is not correct, press At a time, and then re-enter the correct digit(s). You can automatically redial the last number dialled. [. . . ] oVER HEAT The print head has overheated. Operation can be continued after it cools. if overheating frequently occurs , try changing the print contrast setting to LIGHT (see page 18). The print head has failed and requires service. [. . . ]