User manual SHARP FO-210

[. . . ] 24 average pages) 9, 600 bps with automatic fallback to lower speeds. 50 Letter/A4 size sheets (at room temperature; maximum stack height should not be higher than the line on the tray) Legal: 5 sheets Memory size* Modem speed Transmission time* Resolution Applicable telephone line Public switched telephone network Compatibility Input document size ITU-T (CCITT) G3 mode Automatic feeding: Width: 148 to 216 mm Length: 140 to 297 mm Manual feeding: Width: 148 to 216 mm Length: 140 to 600 mm 210 mm max. Mode is for connecting an answering machine) Single / Multi (99 copies/page) Yes (cannot be used if power fails) 220 - 240 V AC, 50/60 Hz 5 - 35°C 25 - 85% RH Standby: 2. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. [. . . ] After transmission, the document is automatically cleared from memory. This function allows you to send the same fax to as many as 20 different locations in just one operation. When sending to multiple locations, only auto-dial numbers can be used to Press (or ) until the name of the number appears in the display (if no name was stored, the number will appear). Repeat Steps 3 and 4 for each of the other locations to which you wish to send the fax (maximum of 20). When you are ready to begin transmission, press Check the "Note" column of the report to see if any of the locations are marked "Busy" or have a communication error code. You can also send a fax through memory when sending to a single location. This is convenient when sending to locations where the line is often busy, as it saves you from waiting to pick up the original document and frees the feeder for other operations. To send a fax through memory, load the document, press dial using one of the following methods: Press the number keys to enter the fax number and then press Press Press Once to select the last number dialled and press If the memory becomes full while the document is being scanned, MEMORY IS FULL and SEE MANUAL will alternately appear in the display. If you want to transmit the pages which have been stored up After transmission, the memory will be cleared and you can transmit the remaining pages. You will also need to transmit the page which was being scanned when the memory filled up. If you want to cancel the entire transmission. If desired, you can use a number other than 5 to activate fax reception from an extension telephone. Enter the desired number (any number from 0 to 9). The fax has been set at the factory to automatically reduce the size of received documents to fit the size of the printing paper. This ensures that data on the edges of the document are not cut off. If desired, you can turn this function off and have received documents printed at full size. If a document is too long to fit on the printing paper, the remainder will be printed on a second page. In this case, the cut-off point may occur in the middle of a line. Automatic reduction may not be possible if the received document is too Large, contains too many fine graphics or images, or is sent at high resolution. In this case, the remainder of the document will be printed on a second page. In situations where printing is not possible, such as when your fax runs out of paper, the imaging film needs replacement, or the paper jams, incoming faxes will be received to memory. When you have received a document in memory, FAX RX IN MEMORY will appear in the display, alternating with ADD PAPER & PRESS START KEY or CHECK FILM / CHECK COVER / CHECK PAPER JAM. [. . . ] If you are attempting to transmit from memory, see If the memory becomes full on page 37. if you are copying , see If MEMORY IS FULL appears on page 47. The fax is preparing to or printing out a document from memory. This appears if you attempt to search for an auto-dial number when none have been stored. [. . . ]