User manual SHARP FO-2200

[. . . ] 50 Letter/A4 sheets (at room temperature; maximum stack height should not be higher than the line on the tray) Legal: 5 sheets Memory size* Modem speed Transmission time* Resolution Applicable telephone line Public switched telephone network Compatibility Input document size ITU-T (CCITT) G3 mode Automatic feeding: Width: 148 to 216 mm Length: 140 to 297 mm Manual feeding: Width: 148 to 216 mm Length: 140 to 600 mm 210 mm max. Mode is for connecting an answering machine) Single / Multi (99 copies/page) Yes (cannot be used if power fails) 220-240 V AC, 50/60 Hz 5 - 35°C 25 - 85% RH Standby: 2. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. the performance specification figures indicated are nominal values of production units. [. . . ] Enter the desired number of rings (any number from 2 to 5). When the reception mode is set to TEL, you must answer all calls by picking up the fax machine's handset or an extension phone connected to the same line. When the fax machine rings, pick up the handset. If the other party first speaks with you and then wants to send a fax, press START/MEMORY after speaking. (Press before the sender presses their Start key. Answer the extension phone when it rings. If you hear a fax tone, wait until the display shows RECEIVING and then replace the handset. If you hear a soft fax tone, wait until your fax responds (the extension phone will go dead), then hang up. Phone goes dead If the fax doesn't respond, or if the other party first talks to you and then wants to send a fax, press 5 once and twice on the extension phone (only on a tone dial phone). The above step is necessary if you have set the Fax Signal Receive setting Your fax will not accept the signal to begin reception (5**) if a document is Putting a call on hold To put the other party on hold during a phone conversation, press When this is done, they cannot hear you. You can put the handset back in the cradle without breaking the connection. Press 1 to set copy cut-off to YES (the remaining part of the document will not be printed), or 2 to set copy cut-off to NO (the remaining part will be printed on a second page). If desired, you can connect an answering machine to your fax machine's TEL. This will allow you to receive both voice messages and faxes when you are out. The outgoing message (OGM) of your answering machine should be changed to inform callers who want to send a fax to press their Start key. For example, your message might go as follows: "Hello. Please leave a message after the beep or press your facsimile Start key to send a fax. Too long, you may have difficulty receiving faxes sent by automatic dialling. If your outgoing message must be longer than 10 seconds, leave a pause Of about four seconds at the beginning of the message. This will give your fax a chance to detect fax tones sent when automatic dialling is used. Your answering machine must be set to answer on a maximum of two rings. If not, you may not be able to receive faxes sent by automatic dialling. [. . . ] If you are attempting to transmit from memory, see If the memory becomes full on page 38. if you are copying , see If MEMORY IS FULL appears on page 48. The fax is preparing to or printing out a document from memory. This appears if you attempt to search for an auto-dial number when none have been stored. [. . . ]