User manual SHARP FO-K01

[. . . ] Do not use this product near water, or when you are wet. For example, do not use this product near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Take care not to spill any liquids on the product. Unplug the product from the power outlet and consult a qualified service representative if any of the following situations occur: - Liquid has been spilled into the product or the product has been exposed to rain or water. [. . . ] Be sure to let the battery charge for 10 hours, and then register the cordless handset as explained on the following page. Charge the battery at least 10 hours the first time! The cordless handset and charger may feel warm while charging. This is normal. The battery cannot be overcharged. When not using the cordless handset, keep it in the charger to ensure that it is always charged. When the battery needs charging, LOW BATTERY will appear in the display and you will hear beeps during a phone conversation. Place the cordless handset in the charger and let it charge. Note: If the battery is extremely low, nothing may appear in the display during the first several minutes that the cordless handset is in the charger. The battery will begin to charge normally after several minutes. Walkie-Talkie capability Two cordless handsets can be used for walkie-talkie like communication. The talking range of the cordless handsets is 360 m (line of sight; talking range may decrease depending on transmission conditions), and there is no need to be in the talking range of the fax machine. Talking range (distance from fax machine) for phone calls The talking range of the cordless handset for phone calls is approximately 360 m (line of sight; talking range may decrease depending on transmission conditions) from the fax machine. If you hear noise or interference while talking, move closer to the fax machine. When outside the talking range, OUT OF RANGE appears in the display. If you move out of the talking range while talking on the cordless handset, the handset will beep and you may hear interference. Aluminum sash Metal Reinforced concrete Large metal objects, metal structures, and thick walls reduce the talking range. 4 Registering the Cordless Handset After the initial charging, the cordless handset display shows: PLEASE REGISTER To use the cordless handset, you must first register it with the fax machine. 1 On the cordless handset, hold down INTER COM Cordless handset display: until the display at right appears. MODE SELECT 1: HS ENTRY 2: HS DELETE 2 Press 1 on the cordless handset. HS ENTRY MODE 3 Fax machine display: On the fax machine, hold down until the display at right appears. INTERCOM MODE SELECT 1: HS ENTRY 2: HS DELETE 4 5 Press 1 on the fax machine. PRESS HS NUMBER On the fax machine, enter a number from 2 to 4. This number identifies the cordless handset. Example: "2" is selected HS2 ENTERED · This completes the registration procedure. Both displays return to the normal standby display Note: If ALREADY STORED appears in the display, the number you selected has already been assigned to another cordless handset. (If you need to use a number that is already in use, delete the cordless handset that uses that number as explained on page 10. ) Note: If you pause more than one minute between any of the above steps, registration will be canceled. 5 English Note: If you take no action for one minute during the registration procedure, the procedure will be canceled. In this case, start from Step 1 again. The fax machine is identified by the number "0", and the cordless handset that was included with the fax is identified by the number "1". Entering a Name for the Cordless Handset Enter a name for the cordless handset in the fax machine. The fax machine will transmit the name that you enter to your cordless handset. The name will appear in the cordless handset's display. 1 2 3 4 Press FUNCTION once and the fax machine. Press once and 3 times on Fax machine display: ENTRY MODE once. HS NAME SET Press once. 1=SET, 2=CLEAR Press 1 to select SET. SELECT HS NO. ENTER (1-4) 5 Enter the number of the cordless handset for which you wish to enter a name. [. . . ] . () CLEAR 2 ( ) ENTER (1-4) ((-) ) . STOP START/MEMORY ( ) : MODE SELECT 1: HS ENTRY 2: HS DELETE INTER COM . ( ) ( :) ( :) : HS2 DELETE: OK? 2 : ) ( ( ) PLEASE REGISTER . [. . . ]