User manual SHARP FU-40SE

[. . . ] The unit controls the ratio of minus cluster ions and plus cluster ions depending on the condition of the room. It is said that plenty of minus ions exist in places such as waterfalls or forests in natural environment. In this operation mode, minus ions will be released in an increased rate, in order to bring the room air close to this condition. The unit will switch between the Clean mode and Refresh mode automatically depending on the amount of pollution in the air detected by dust and odor sensor. [. . . ] (Lights when the power plug is inserted into the wall outlet) ) (Detects dust, smoke, pollen, house dust, etc. Clean-sign lamp The color changes when the air is dirty Clean (green) Little dirty (orange) Very dirty (red) The dust sensor displays a clean sign depending on the relative change of the environment at the time the power plug is inserted in the wall outlet and after. When the air is extremely dirty at the time the power plug is inserted, the clean sign lamp may light green since the polluted state is the environment which the sensor bases the pollution rate on. In this case, switch manually to desirable operation as effective operation can't be done in auto operation. To reset the base pollution rate of the clean-sign lamp remove and insert the power plug again the room air becomes clean. (Used to select operations or turn the unit off) When the cluster ion operation is in the Clean mode or AUTO cluster ion mode and the air in the room is dirty, the light turns on and the unit will operate in the Clean mode. When the cluster ion operation is in the Refresh mode or AUTO cluster ion mode and the air in the room is dirty, the light turns on and the unit will operate in the Refresh mode. If the lamp is bright when sleeping, or if the ion generation noise is irritating, turn off the cluster ion operation. Thumbscrew (2 units) Located on bottom of stand When using this product to a wall Wall mounting bracket 1 Wall mounting bracket 2 Wood screw (4 units) Small screw (2 units) Cushions (2 units) When mounting the air purifier to the wall, the mounted wall will become dirty as time passes. A wall side to install is to choose the place to have the strength done firmly. In the case of a wall or concrete wall with little strength, request installation to a specialist such as an electric appliance shop, etc. Do not install in a location with heavy lampblack, such as in a kitchen, etc. The unit with its 2 Placefacing down on afront side flat and stable surface. Leave space around the bracket by referring to the illustration below. The unit cannot be mounted if there is insufficient spacing around the bracket. 75cm or more 69cm or more from the ceiling Size of main unit 75cm or more 75cm or more Tabs 3 Insert theholes on the stand into the on the main unit and fix the stand using the included thumbscrews (2 units). Mounting bracket 1 60cm or more from 60cm or more sidewall from sidewall Do not mount the unit to a location that is not flat such as a wall with a door header, etc. Do not mount the unit to a thin wall with little strength such as a plasterboard, etc. The unit may fall and can be very dangerous. Install it after you ask a specialist and you can get the confirmation of the strength. Mount the bracket using the included wood screws (long screws) so that it level. Use 4 wood screws (long screws) (2) Hold the bottom of the main unit, pull the unit towards you and then pull down. [. . . ] For soiling on the main unit and the installed surface, clean as early as possible. Clean using the nozzle of a vacuum cleaner without removing the pre-filter. Was the air already dirty when the power plug was inserted into the wall outlet? (Refer to E-4) · The sensitivity of the sensor becomes unstable when the opening of the dust sensor is dirty or is clogged. [. . . ]