User manual SHARP FU-40SE-K

[. . . ] R FU-40SE-K AIR PURIFIER OPERATION MANUAL Tabletop / wall-mounting type ENGLISH FEATURES Cluster Ion Control The unit controls the ratio of minus cluster ions and plus cluster ions depending on the condition of the room. CONTENTS SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . E-2 · CAUTIONS CONCERNING THE USAGE OF THIS PRODUCT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-3 · CAUTIONS WHEN MOUNTING THIS PRODUCT ON A WALL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-3 · CAUTIONS CONCERNING THE INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The unit surface may become damaged or cracked. In addition, the sensors may malfunction as a result. · When transporting the unit, always hold the handle on the back of the unit. Holding the front panel when carrying may cause it to detach, thus dropping the unit and resulting in bodily injury. CAUTIONS WHEN MOUNTING THIS PRODUCT ON A WALL · Never mount the unit to a thin wall or plasterboard of insufficient strength. · When mounting the unit to a wall, remove the front panel and hold the main unit. Holding the front panel may cause it to become detached, thus dropping the unit and resulting in bodily injury. · Do not install when there is generation of lampblack, such as in a kitchen, etc. The unit surface may crack or the sensors may malfunction as a result. CAUTIONS CONCERNING THE INSTALLATION DO NOT USE THE REMOTE CONTROL IN THE FOLLOWING LOCATIONS · Locations where there are inverter lighting equipment or electronic spontaneous lighting equipment The remote control may become inoperative. In this case, move away from such lighting equipment or change direction. · Location exposed to direct sunlight The unit may not received signals from the remote control INSTALLATION · Leave at least 2m of space from televisions and radios Electrical interference may occur if not. · Leave at least 60cm of space from the wall The motor may overheat, causing malfunction if not. · Avoid a location where sensors are exposed to direct wind The unit may not operate properly. · Avoid a location where curtains, etc. , come into contact with the intake or exhaust port. Curtains, etc. , may become dirty or malfunction may occur as a result. EFFECTIVE USAGE · Place on a stable surface with sufficient air circulation · Near smoking area Air pollution is detected quickly. ABOUT THE FILTER · Do not wash or reuse Apatite HEPA filter and deodorization filter. · Small dust particles and odors such as tobacco smoke rise and accumulate at the top of the room. · Large dust such as pollen and house dust accumulate at the bottom of the room. · The wall, etc. , behind the exhaust port may become dirty as time passes. When using the unit for extensive period in the same location, use a vinyl sheet, etc. , to prevent the wall from becoming dirty. In addition, periodically clean the wall, etc. E-3 NAMES OF PARTS MAIN UNIT DISPLAY noxious substances *It can not remove thecigarette smoke. (carbon monoxide etc. ) from Power lamp (Lights when the power plug is inserted into the wall outlet) Tobacco smoke mode operation lamp Filter timer lamp AUTO operation lamp Pollen mode operation lamp * Fan level lamps OFF timer display lamps (set using remote control) Plasmacluster High Silent Median Max Remote control receiver Dust sensor Odor sensor (Detects odors such as tobacco smoke, incense, pets, cosmetics, etc. ) (Detects dust, smoke, pollen, house dust, etc. ) Clean-sign lamp The colour changes when the air is dirty Clean (green) Little dirty (orange) Very dirty (red) ABOUT THE CLEAN-SIGN LAMP · The dust sensor displays a clean sign depending on the environment at the time the power plug is inserted in the wall outlet. · When the air is extremely dirty at the time the power plug is inserted, the clean sign lamp may light green since the polluted state is the environment which the sensor bases the pollution rate on. · In this case, switch manually to the desirable operation mode as effective operation can't be done in auto operation. [. . . ] A short beep will be heard and the operation hours stored in the memory will be reset. If the filter replacement lamp is on, the lamp will turn off. Fill in the usage start date of the filters on the date label included with the replacement filters. Affix the label on top of the replacement label that is already on the back of the front panel. Replacement filters · HEPA filter: 1 unit · Stamina-power carbon: 1 unit Model: FZ-40SEF Please ask for replacement filters at your dealer of purchase. Cautions concerning the disposal of filters Please dispose of replaced filters according to the local disposal laws and regulations. HEPA filter materials: · Filter: Polypropylene · Frame: Polyester Stamina-power carbon materials: · Deodorizer: Activated charcoal · Frame: Polyester E-13 TROUBLESHOOTING Before calling for repair, check the symptoms below for possible remedies, since the problem may not be a malfunction of the unit. SYMPTOM The remote control does not work Odors and smoke cannot be removed easily The Clean sign lights green even when the air is dirty The Clean sign lights orange or red even when the air is clean The cluster ion lamp remains green (blue) and does not change A sound is heard from the unit Click, click REMEDY (not a malfunction) · Have the batteries depleted? [. . . ]