User manual SHARP FU-S51E

[. . . ] Please read before operating your new Air Purifier The air purifier draws in room air from its air intake, lets the air pass through a Active Carbon Filter (deodorization filter) and a HEPA Filter (dust collection filter) inside of the unit, then discharges the air from its air outlet. The air purifier unit repeats this process by moving its internal fan. As air passes through, a new HEPA Filter can remove 99. The Active Carbon Filter gradually absorbs odour elements as they repeatedly pass through the filter. [. . . ] To maintain the quality of the filters, they are installed in the main unit and packed in plastic bags. Be sure to remove the filters from the plastic bags before using the unit. Pull the Front Panel on the lower sides, and lift up. Push in the hooks on top, then pull the Filter Support. From 5 Remove the Active Carbon Filter from the carton box, and also remove the plastic bag. Please make sure that the HEPA Filter(blue) and the tab is placed in proper direction. Do not install the filter backwards or the unit will not operate properly. Place the Front Panel from the obliquely upward, then mount the hooks at the bottom. Unless unplug the power cord, the operation starts in the previous mode the unit was operated in. When stop operation during ION SHOWER Operation, the unit will back to the prior operation of ION SHOWER Operation. The unit will operate quietly using minimal air intake. The unit will operate at HIGH* fan speed for 10 minutes, then will alternate between MEDIUM and HIGH* for 20 minutes. 10 minutes: HIGH fan speed 20 minutes: MEDIUM fan speed 20 minutes: HIGH fan speed The unit will operate at a fan speed of MEDIUM. The unit will operate at a fan speed of MAX. * HIGH fan speed is an intermediate speed between MEDIUM and MAX. (Direct start is available even when the unit is not turned on. ) The concentrated Plasmacluster Ions (ION SHOWER) will be generated in the room like a shower for 15 minutes, repeating the airflow cycles between strong and gentle. (The Plasmacluster Indicator Light repeats its colour cycles between blue and green. When the operation finishes, the unit will return to the prior operation. When pushing the ION SHOWER button while the ION SHOWER operation mode is working, the unit will return to the prior operation. The unit will switch between Clean Mode and the Ion Control Mode* automatically depending on the amount of impurities in the air as detected by the dust and odour sensors. Clean Mode will operate for 10 minutes when the Auto function is selected. [. . . ] Clean or replace the filters if they appear to be heavily soiled. (Refer to E-11 , E-12) · The air could be impure at the time the unit was plugged in. (Refer to E-5) Pull out the plug from the electrical outlet, and insert the plug one minute later. The sensitivity of the sensors become unstable when the opening of the odour sensor or dust sensor is dirty or is clogged. [. . . ]