User manual SHARP FU-425E

[. . . ] The unit controls the ratio of negative ions and positive ions depending on the condition of the room. Approximately the same numbers of positive and negative ions are discharged. This mode is effective for reducing some airborne mold. Plenty of negative ions exist in natural surroundings such as waterfalls or forests. [. . . ] The unit will operate at HIGH* fan speed for 15 minutes, then will operate at Auto operation. The unit will operate at a fan speed of MEDIUM. The unit will operate at HIGH* fan speed for 10 minutes, then will alternate between MEDIUM and HIGH for 20 minutes. 10 minutes: HIGH fan speed 20 minutes: MEDIUM fan speed 20 minutes: HIGH fan speed The unit will operate quietly using minimal air intake. * HIGH fan speed is an intermediate speed between MEDIUM and MAX. For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will check the conditions of the air. If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash in green, orange and red. When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmacluster Ion Mode and the air in the room is impure, the light will activate and the unit will operate in Clean Mode. When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO Plasmacluster Ion Mode and the air in the room is clean, this light will activate and the unit will operate in Ion Control Mode. There are no Plasmacluster ions being generated. The light can be turned off by using the `Lights ON/OFF Button' on the Remote Control. In this case, Plasmacluster ions are generated. (Please turn off the light when not required. The condition of the CLEAN-SIGN depends on the room air condition ABOUT THE CLEAN-SIGN the plug is inserted into the wall outlet. Thepossible to of theaCLEAN-SIGN depends on the room air condition · It is condition have green CLEAN-SIGN with impurities in the air at the detected by air Odor Sensor when the plug is inserted environment. After time that thethe purifier was just introduced to the room into the wall outlet. It while, however, thea green CLEAN-SIGN with impurities detect air at the a is possible to have base impurity rate will be adjusted to in the room air time that correctly. A while, however, ON/OFF impurity on the remote control detect roomthe Use the Display the base Button rate will be adjusted to to turn off air conditon light. Use the Lights ON/OFF Button on the remote control to turn off the Indicator light. When you press the POWER ON/OFF Button, a short beep will sound and operation will start in AUTO Mode. Unless unplug the power cord, the operation starts in the previous mode the unit was operated in. The fan speed can be switched among Silent, Medium and MAX settings. [. . . ] You might be charged for the costs arising from take-back and recycling. Small products (and small amounts) might be taken back by your local collection facilities. For Spain: Please contact the established collection system or your local authority for take-back of your used products. In other Countries outside the EU If you wish to discard of this product, please contact your local authorities and ask for the correct method of disposal. [. . . ]